Bosch Pump-drain Washer, 120V 00436440

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Water remains in the washer after the drain portion of the cycle.
• The washer may stop before completing the cycle when the drain pump is blocked or unable to remove water.
• A blocked pump can prevent the washer from proceeding to or completing spin.

Check Before Replacing

• Disconnect electrical power before inspecting the pump area.
• Drain remaining water slowly through the washer's designated drain hose or pump-access drain provision, using a suitable container.
• Inspect the pump/filter area for debris that could block the impeller or pump inlet.
• Check the drain hose and drain pipe for kinks or blockage.
• Confirm the pump cap is fully seated and correctly secured after inspection.
• If the pump does not operate after blockages and hose issues are addressed, have an authorized technician perform electrical and component testing.

Pro Tip

Part Details

Installation Notes

• Install the pump with the supplied hose, clamp, and plug as specified by Bosch.
• For WFMC/WFXD Nexxt washers, do not remove the supplied hoses, hose clamps, or plugs from the pump.
• For applicable four-shock Vision washers WFVC UC/26 and later, Bosch states that the supplied drain hose may be too short and the existing washer drain hose must be reused.
• Drain residual water before opening the pump area and follow the appliance-specific service instructions; improper repair can affect appliance safety.

Verified Compatible Models

Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.