134149220 Washer Spin Control Board Assembly – AP2107167 Replacement for Frigidaire, Electrolux
If your Frigidaire or Electrolux washer stops mid-cycle, won’t spin, or throws a spin-related error code, the spin control board assembly is the most likely cause. In most Frigidaire-built washers, the spin control board governs motor speed and direction during the spin cycle — when it fails, the drum may agitate but refuse to spin up to speed, stop abruptly mid-cycle, or display fault codes and lock out entirely. ⚡ Common failure point in Frigidaire and Electrolux-built washers. Part 134149220 is the direct-fit replacement spin control board that restores full spin cycle operation with no modification required.
Frigidaire Washer 134149220
Is This the Right Part?
Confirm the complete model number before ordering. Similar parts may use different connectors, dimensions, hose positions, electrical ratings, or mounting points.
- ✔ Your washer powers on and the control panel responds normally
- ✔ The wash/agitate cycle runs — only the spin cycle fails or is weak
- ✔ The lid switch or door latch is confirmed functional and closed properly
- ✔ The drive motor runs but the drum does not reach spin speed
- ✔ ONLY problem is spin cycle failure, premature stop, or spin-related error code
- Washer not spinning — most common customer search
- Drum agitates normally but will not spin up to speed
- Washer stops mid-cycle during spin with wet clothes inside
- E or F error code displayed during or before spin cycle
- Spin cycle starts then immediately stops or reverses
- Washer completes wash but skips spin entirely — clothes soaking wet at end
- Part Number: 134149220
- Type: Washer spin control board assembly — motor speed controller PCB for spin cycle regulation
- Replaces: OEM direct-fit control board — supersedes 134393900, 134149221, AP2107167, PS418428 (no modification required)
- Brands: Frigidaire, Electrolux, White-Westinghouse, Gibson, Kelvinator
Before ordering a spin control board, test the motor start capacitor with a multimeter — a failed capacitor produces identical symptoms (motor hums but won’t spin up) and costs a fraction of the board. If the capacitor tests good and the motor runs freely by hand, the spin control board is the confirmed next step.
Part Details
Use a qualified technician when diagnosis or installation is outside your experience. Gas parts should be installed by a licensed technician.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
