Frigidaire Refrigerator Water Inlet Valve Assembly 242252702, Replaces 240321801, 240505101, 240505102, 240508101, 240508102, 240531101, 241734301, 241734302, 7241734301

Genuine OEM refrigerator triple-solenoid water inlet valve assembly that supplies water to the ice maker and door dispenser. The assembly includes the valve and mounting bracket; some replacement versions may use quick-connect fittings instead of older screw-type fittings.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Water dispenser does not dispense or has restricted flow
• Ice maker does not fill or produces undersized ice
• Water leaks into the ice maker or refrigerator when the valve should be closed
• Water leakage at the valve or its tubing connections
• A valve may buzz or hum while failing to deliver water

Check Before Replacing

• Confirm the refrigerator’s household water supply valve is open and that water flows from the supply line.
• Check for a kinked or frozen refrigerator water tube before condemning the valve.
• Inspect the valve, tubing, and connections for visible leakage with the water supply turned on.
• Disconnect electrical power before removing panels or accessing the valve.
• With power disconnected and the valve isolated, check each applicable solenoid coil for continuity with a multimeter; compare results with the resistance specification marked on the valve or the applicable service documentation.
• If the appliance has adequate water pressure but the valve does not open, does not close, or has an electrically open coil, the valve may be defective; confirm other dispenser and ice-maker controls before replacement.

Pro Tip

Part Details

Key Features

• Genuine Frigidaire refrigerator water inlet valve assembly
• Triple-solenoid design for separate water functions
• Supplies both the ice maker and door dispenser
• Includes the valve and mounting bracket
• Replacement versions may use push-in quick-connect tubing fittings in place of older screw-type connections

Installation Notes

• Disconnect electrical power and shut off the refrigerator water supply before servicing.
• Place a container or towel beneath the valve to catch residual water.
• Remove the rear access panel and document the original tube and wire locations before disconnecting them.
• Inspect tubing ends and fittings before installation; damaged or uneven tubing ends may need to be prepared for the replacement valve’s fitting style.
• Reconnect each water tube and electrical connector to its original location, secure the valve and bracket, then restore water and power.
• After installation, inspect all connections for leaks and verify both dispenser and ice-maker water operation.

Verified Compatible Models

CFD27SDPS0, CFD28SDQS0, CRSE233TB0, CRSE233TS0, CRSE233TW0, CRSE263TB0, CRSE263TD0, CRSE263TS0, CRSE263TW0, CRSH232PB0, CRSH232PB2, CRSH232PB3, CRSH232PB5, CRSH232PB6, CRSH232PB7A

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.