The 4861FR3068A is the genuine OEM LG hose clamp designed to secure water inlet and drain hoses on LG front-load washers and compatible dryer models. A failed or loose hose clamp is a common cause of water leaks at the back or bottom of the machine. This is a simple, low-cost fix that prevents water damage and restores a watertight seal.

✓ Model-Specific Repair Pages

The 4861FR3068A hose clamp secures the end of the water inlet or drain hose to its fitting, maintaining a watertight connection through thousands of wash cycles. Compatible with a wide range of LG front-load washers (WM series) and LG dryers (DLEX/DLGX series), as well as select LG washer-dryer combo units.

✓ Common Symptoms Fixed

• Water leaking from the back or bottom of the washer
• Hose slipping off its fitting during operation
• Visible water pooling under the machine after a cycle
• Loose or corroded hose clamp causing intermittent leaks

✓ Key Features & Specifications

• Genuine LG OEM hose clamp — exact factory fit
• Secures water inlet and drain hoses to prevent leaks
• Durable construction for long-lasting watertight seal
• Direct replacement — no modification required
• Compatible with LG WM, DLEX, DLGX, WD, and RN series models

✓ Buying Options

OEM — The 4861FR3068A is the genuine LG OEM hose clamp, manufactured to original factory specifications for a guaranteed watertight fit.

XPart Supply Ltd. aftermarket replacement parts are not affiliated with, sponsored by, or endorsed by LG or any OEM manufacturer.

✓ Replacement Part Numbers

4861FR3068A

✓ Installation Tips

Unplug the washer and turn off the water supply valves before beginning. Locate the hose connection at the back of the machine or inside the cabinet depending on your model. Use pliers to slide the old clamp back along the hose, then pull the hose free from the fitting. Slide the new clamp onto the hose, reattach the hose to the fitting, and position the clamp approximately 1 cm from the end of the hose over the fitting bead. Squeeze or tighten the clamp securely. Restore water supply and run a short cycle to verify no leaks before pushing the machine back into position.