Washer Not Agitating or Spinning? Transmission Assembly 5304517318 – Fix No-Agitate & No-Spin Fast

If your Frigidaire or Electrolux front-load washer drum isn't moving, agitating, or spinning properly, the transmission assembly is the most likely cause. In most Frigidaire-platform washers, this is caused by a failed transmission assembly. When it fails, the drum loses mechanical drive — the washer may run through a cycle with no agitation, fail to spin, make loud grinding or clunking noises, or stop mid-cycle. ⚡ Common wear-out failure in Frigidaire-built washers after high-cycle use or overloading. Part 5304517318 is the genuine OEM replacement that restores full mechanical drive — agitation, spin, and drum rotation — to factory specification.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and fills with water normally
• ✔ Door latch, motor, and control board have been ruled out
• ✔ Power supply to the unit is confirmed OK
• ✔ ONLY problem is no agitation, no spin, or loud mechanical noise during the wash or spin cycle

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Drum does not agitate during the wash cycle
• Washer fills and drains but drum does not spin
• Loud grinding, clunking, or rumbling noise during operation
• Washer stops mid-cycle with no error code
• Clothes come out soaking wet — spin cycle not completing
• Visible wobble or resistance when drum is turned by hand

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this transmission assembly restores normal agitation and spin immediately.

📦 Part Details

• Part Number: 5304517318
• Type: Washer Transmission Assembly (Mechanical Drive Unit)
• Replaces: 5304517318 (current OEM — verify no superseded numbers with your model)
• Brands: Frigidaire, Electrolux

⚙️ Installation

Skill Level: ADVANCED — 90–120 min. Significant disassembly required. Disconnect power and water supply before servicing. The transmission assembly requires removing the front panel, drum, and motor assembly to access. Photograph all wire harness and hose connections before disconnecting. Torque all fasteners to spec on reassembly and run a full test cycle before closing up the machine.

✓ Compatible Models

Confirmed compatible with FFLE3900UW0, FFLE3900UW1, FFLE3900UW2, FFLE3900UW3, FFLG3900UW0, FFLG3900UW1, FFLG3900UW2, FFLG3900UW5, FLCE7522AW0, FLCE7522AW1, FLCE7522AW2, FLCE7522AW3, FLCE7523AW0, FLCE752CAW0, FLCE752CAW1, FLCG7522AW0, FLCG7522AW1, CFLE3900UW0, CFLE3900UW1, CFLE3900UW3, 41761732810, 41761732811, 41761733810, 41771732810, 41771733810, 41771733811 plus additional Frigidaire and Electrolux models. Contact us to verify your model number before ordering.

💡 Pro Tip