Pit Boss Pellet Grill Igniter Hot Rod 70112 – 200 Watts

The Pit Boss 70112 Igniter Hot Rod is the heating element responsible for igniting wood pellets at startup. When it fails, the grill will not light, the auger will run but no fire starts, or the grill shuts down on ignition errors. This 200W hot rod measures 3.5 inches in length and 3/8 inch in diameter and is a direct-fit replacement for the standard igniter used across a wide range of Pit Boss pellet grill models.

Is This the Right Part?

Confirm your grill model number before ordering. Verify the igniter length and diameter match your existing hot rod before installation.

Common Symptoms

• Grill will not light or ignite at startup
• Auger feeds pellets but no flame or smoke develops
• Grill displays ignition error or shuts off during startup cycle
• Igniter glows but pellets do not catch
• Grill takes excessively long to reach temperature

Check Before Replacing

• Test the igniter with a multimeter — a working 200W igniter should show approximately 65–70 ohms resistance
• Confirm the igniter is seated fully in the firepot and making solid contact
• Check that the firepot is clear of ash buildup blocking airflow around the igniter tip
• Verify the control board is sending power to the igniter during the startup cycle

Part Details

Installation Notes

1. Disconnect the grill from power before beginning.
2. Remove the grill grates, heat deflector, and drip tray to access the firepot.
3. Photograph the igniter wiring and mounting position before removal.
4. Unplug the igniter connector and remove the mounting screw securing the hot rod.
5. Slide the old igniter out and insert the new 70112 hot rod, securing with the mounting screw.
6. Reconnect the wiring, reassemble the grill, and run a startup cycle to confirm ignition.

Use a qualified technician if you are unsure about any step. Always clean the firepot of ash before testing the new igniter.

Verified Compatible Models

Fits a wide range of Pit Boss pellet grill models. Verify your model number and confirm igniter dimensions (3.5" × 3/8") match before ordering. Contact us if you need help confirming compatibility.

Fitment reminder: Match the complete model number, including suffixes and revision digits, before ordering.