Oven Not Heating? Electric Head 806827 – Fix ECH Failure on Garland Commercial Ovens Fast

If your Garland commercial oven is failing to heat, cycling erratically, or the electric head is not responding, the ECH assembly is the most likely failed component. In Garland DF and IR series ovens, the 806827 electric head controls the primary heating function — when it fails, the oven produces no heat or operates inconsistently, bringing kitchen operations to a halt. ⚡ Common failure point in Garland DF30, DF36, IR304, and IR365 commercial ovens. Part 806827 is the genuine OEM replacement ECH assembly that restores full heating performance immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Oven powers on and controls are responsive
• ✔ Gas supply (if applicable) and electrical supply confirmed normal
• ✔ Other oven functions (controls, ignition) are unaffected
• ✔ Model is confirmed as DF30, DF36, IR304, or IR365
• ✔ ONLY problem is the oven not heating or heating erratically from the ECH

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Oven produces no heat despite powering on — most common complaint
• Oven heats inconsistently or cycles off prematurely
• Electric head visibly damaged, burned, or corroded
• Oven fails to reach or hold set temperature
• Harness connection to ECH shows arcing or heat damage
• Unit was previously repaired but ECH failure has recurred

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing the electric head assembly restores full oven operation immediately.

📦 Part Details

• Part Number: 806827
• Type: Oven Electric Head (ECH) Assembly — single ECH with control harness, OEM direct fit
• Includes: ECH harness from ECH to control (no separate harness purchase required)
• Compatible Models: Garland DF30, DF36, IR304, IR365
• Brand: Garland (Manitowoc Foodservice)

⚙️ Installation Notes

Skill Level: MODERATE — 30–45 minutes. Disconnect power to the oven at the breaker before beginning — do not work on live commercial equipment. Remove the existing ECH assembly by disconnecting the harness and unbolting the head from its mounting position. Install the new 806827 assembly, reconnect the included harness to the control, and secure all mounting hardware. Restore power and test across all heat settings to confirm full operation. Consult the Garland service manual for your specific model if torque specs are required.

💡 Pro Tip