Dishwasher Not Dispensing Detergent? Dispenser Box 700275 – Fix No-Release Fast
If your ASKO dishwasher is leaving dishes dirty because detergent isn't releasing during the wash cycle, the dispenser box is the most likely cause. In most ASKO dishwashers, the dispenser box houses the detergent door latch, spring, and release mechanism as a single assembly. When it fails, detergent stays locked in the compartment throughout the entire cycle — leaving dishes greasy, spotted, and unwashed. ⚡ Common wear item in ASKO-built dishwashers, especially in older units with high cycle counts. Part 700275 is the genuine OEM replacement that restores full detergent dispensing and gets your ASKO cleaning properly again.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Dishwasher powers on and runs full cycles normally
- ✔ Water fills and drains correctly — no error codes
- ✔ Rinse aid dispenser works fine — only detergent side is affected
- ✔ ONLY problem is detergent door not opening or detergent remaining in compartment after cycle
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Detergent tablet or powder remains in the dispenser after a full cycle
- Dispenser door does not open during the wash cycle
- Dishes come out greasy, filmy, or not fully cleaned
- Dispenser door latch is broken, cracked, or won't stay closed before the cycle
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this dispenser box assembly restores full detergent release and normal cleaning performance immediately.
📦 Part Details
- Part Number: 700275
- SKU: A040260G
- Type: Dishwasher Detergent Dispenser Box — complete assembly including door, latch, spring, and release mechanism
- Replaces: 700275 (OEM ASKO)
- Brands: ASKO
While the inner door panel is open, inspect the door latch wax motor or bi-metal actuator that triggers the dispenser release — if the dispenser box is worn, the actuator often is too. Replacing both at the same time eliminates the most common cause of repeat dispenser failures.
⚙️ Installation
Skill Level: MODERATE — 20–35 minutes. Disconnect power before servicing. Open the dishwasher door and remove the inner door panel screws to access the dispenser assembly mounted on the door liner. Disconnect the wiring harness from the dispenser, unscrew the mounting fasteners, and swap in the new unit. Reconnect the harness and reassemble the door panel.
✓ Compatible Models
Confirmed compatible with select ASKO D-series dishwasher models. Compatibility varies by production year and model suffix. Contact us to verify your model number before ordering.
💡 Pro Tip
Powder and gel detergents are harder on dispenser door springs and latches over time — especially in high-humidity environments. Switching to a quality pod or tab after replacing the dispenser box extends the life of the new assembly significantly and reduces the chance of a repeat failure.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
