Oven Not Baking or Bottom Heat Gone? Bake Element C30R05-091200 – Fix Bake Failure Fast

A failed bake element is the most common reason a Forno range oven stops heating from the bottom, produces uneven baking results, or won’t reach set temperature. In the Forno FFSGS6188-48 range, the bake element is the lower heating element that provides the primary heat source for baking and roasting. When it burns out or fails, the oven may not heat at all, heat only from the top, or cycle on and off erratically. ⚡ Most common oven repair on the Forno FFSGS6188-48 range. Part C30R05-091200 is the genuine OEM bake element that restores full bottom-heat baking performance immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Range powers on and control panel is responsive
• ✔ Broil element (top) heats normally when broil mode is selected
• ✔ Oven temperature sensor tests within spec (approximately 1,080–1,090 ohms at room temperature)
• ✔ Bake element is visibly burned, blistered, cracked, or shows an open circuit on continuity test
• ✔ ONLY problem is oven not heating from the bottom in bake mode

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Oven not heating in bake mode — most common complaint
• Food undercooked on the bottom while top browns normally
• Oven takes much longer than normal to reach set temperature
• Visible burn marks, blistering, or a hole in the bake element
• Oven trips the breaker when bake mode is selected
• F-series error code related to bake circuit displayed on the control panel

✔ If these symptoms match, this is the most likely failed component in the oven heating system.

✔ In most cases, replacing this bake element restores full baking performance immediately.

📦 Part Details

• Part Number: C30R05-091200
• Type: Oven Bake Element (lower heating element)
• Fits: Forno FFSGS6188-48 range (confirm your model number before ordering)
• Brands: Forno

⚙️ Installation

Skill Level: EASY — 15–20 minutes. Disconnect power at the breaker before beginning — bake elements carry line voltage. Remove the oven racks to access the element. Remove the two mounting screws securing the element to the back wall of the oven cavity, gently pull the element forward to expose the wire terminals, and disconnect the two spade connectors. Connect the new element to the terminals, push it back into position, and secure with the mounting screws. Restore power and run a bake cycle to confirm full heat output before replacing the racks.

💡 Pro Tip

Find parts for your range model: FFSGS6188-48