WR60X187 GE Condenser Fan Motor for Refrigerators, Fixes Warm Temperatures or Compressor Overheating

🇺🇸 Matching U.S. Part Number: WR60X187

The GE WR60X187 condenser fan motor and hardware assembly turns the fan blade to move air across the condenser coil and compressor compartment. On applicable refrigerators, the airflow also helps evaporate water from the drain pan. WR60X187 is the current genuine GE OEM replacement for discontinued number WR60X179 and all verified predecessor numbers listed below.

A seized, noisy or electrically failed motor may contribute to warm refrigerator temperatures, compressor-compartment overheating, extended compressor operation, or abnormal fan noise. Similar symptoms can also result from a blocked condenser, damaged fan blade, loose mounting hardware, wiring fault, failed start components, compressor problem, or sealed-system condition.

Confirm the complete refrigerator model before ordering. Genuine WR60X187 uses three round-pin connection terminals and is rated 115V. Disconnect electrical power before servicing the condenser compartment.

Is This the Right Part?

Confirm the complete model number before ordering. Similar parts may use different connectors, dimensions, voltage ratings, or mounting points.

Common Symptoms

• Refrigerator or freezer running warm despite compressor operating
• Condenser fan blade not spinning when refrigerator is running
• Compressor running hot or cycling off on thermal overload
• Rattling, squealing, or grinding from the compressor compartment
• Compressor running for extended periods without reaching temperature

Check Before Replacing

• Spin the fan blade by hand with power disconnected — it should turn freely with no resistance
• Inspect the condenser coils for dust or debris blockage
• Check the electrical connector and wiring harness for damage or corrosion
• Inspect the condenser fan blade for cracks, warping, or contact with housing

Part Details

Installation Notes

1. Disconnect power and confirm the refrigerator is unplugged before servicing.
2. Pull the refrigerator away from the wall and remove the rear access panel.
3. Photograph wiring, connector orientation, and mounting positions before disassembly.
4. Disconnect the motor wiring harness and remove mounting screws.
5. Compare the new motor with the original before installation — verify connector type, shaft, and mounting pattern.
6. Reinstall the fan blade, reconnect the harness, and secure the access panel.
7. Restore power and confirm the fan spins freely when the compressor starts.
8. Check for unusual sounds or error codes after first run.

Use a qualified technician when diagnosis or installation is outside your experience.

Verified Compatible Models

3639606592, CTX18GLJRAD, MSX20GLC

Fitment reminder: Match the complete model number, including suffixes and revision digits, before ordering. Contact us to verify your model number.