Washer Won't Power On? W10132081C Power Cord – Fix No-Power Fast
A dead washer that won't respond at all is almost always a power delivery problem — and the cord is the first place to check. In most Whirlpool and Maytag top-load and front-load washers, this is caused by a failed power cord. When it fails, the machine receives no power, displays no lights, and will not start any cycle regardless of settings. ⚡ Common failure point in Whirlpool-built washers across multiple model lines. Part W10132081C is the genuine OEM replacement that restores full power delivery and gets your washer running again.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ QUALIFIER 1 — the wall outlet is confirmed live and supplying correct voltage
- ✔ QUALIFIER 2 — the circuit breaker has not tripped and the outlet tests OK
- ✔ QUALIFIER 3 — the lid/door switch and control board show no visible damage
- ✔ ONLY problem is the washer has zero power — no lights, no display, no response
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Washer completely dead — no lights, no display, no sounds
- Machine does not respond to any button presses
- Visible burn marks, melting, or scorch smell near the cord or plug
- Cord feels loose, damaged, or shows exposed wiring at the strain relief
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this power cord restores normal operation immediately.
📦 Part Details
- Part Number: W10132081C
- Type: OEM Washer Power Cord — 4-wire, 240V, 30A rated
- Replaces: W10132081A, W10132081B
- Brands: Whirlpool, Maytag, Amana
Inspect the terminal block and strain relief while the cord is disconnected — if the block shows any arcing or corrosion, replace it at the same time to prevent repeat failures and ensure a safe, code-compliant repair.
⚙️ Installation
Skill Level: EASY — 15–20 minutes. Disconnect power before servicing. Remove the rear access panel, disconnect the old cord from the terminal block, and connect the new cord matching wire colours to the correct terminals. Secure the strain relief clamp and reinstall the panel.
✓ Compatible Models
Confirmed compatible with WTW4816FW2, WTW4950XW0, WTW5000DW1, WTW6120HW0, MHW5500FW0 plus additional Whirlpool and Maytag models. Contact us to verify your model number before ordering.
💡 Pro Tip
A burned power cord is often caused by a loose or corroded terminal block connection — not just cord wear. If you only replace the cord without inspecting the block, the new cord can fail again within months. Replacing both at the same time is the professional standard and saves a second service call.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
