Induction Range Not Heating or Burners Not Responding? Induction Module W10857233 — Fix Induction Failure Fast

An induction range with one or more burners that won’t heat, respond to touch, or hold power is almost always a failed induction module — not a wiring or control board issue. In most Jenn-Air JIC4536-series induction ranges, this is caused by a failed induction power module. When it fails, the affected burner zones go completely dead, the cooktop may display error codes, and no amount of resetting restores function. ⚡ Common failure point in Jenn-Air-built induction ranges — and this part is No Longer Available from the manufacturer. Part W10857233 is the genuine OEM replacement that restores full induction burner function — order now while stock lasts.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your range powers on and the display and controls function normally
• ✔ One or more induction burner zones produce no heat despite correct pan placement
• ✔ Power supply to the range is confirmed — breaker is on, voltage is correct
• ✔ Induction-compatible cookware is confirmed — magnet test passes on the pan
• ✔ ONLY problem is induction burner failure — not the touch controls, display, or oven

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Induction burner zone completely dead — no heat, no response — most common complaint
• Burner activates briefly then shuts off immediately
• Error code displayed on cooktop panel (F-codes or E-codes)
• Clicking or buzzing from under the cooktop with no heat output
• Multiple burner zones fail simultaneously after a power surge
• Range trips the circuit breaker when a burner zone is activated

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this induction module restores full burner function immediately.

📦 Part Details

• Part Number: W10857233
• Type: Range Induction Power Module — controls induction heating coil activation and power delivery
• Replaces: OEM direct-fit induction module — supersedes W10607548, W10704015, W10794957, W10871147, WPW10607548 (no modification required)
• Brands: Jenn-Air
• ⚠️ Status: No Longer Available (NLA) — discontinued by manufacturer. This is genuine OEM old stock. No restock expected.

⚙️ Installation

Skill Level: Advanced — 45–60 minutes. Disconnect power at the circuit breaker and confirm voltage is zero before opening the cooktop — induction modules store charge and must be treated as live until fully discharged. Remove the cooktop glass or top panel per your service manual to access the module mounting location; disconnect the harness connectors, remove the mounting screws, and swap the module. Reconnect all harness plugs fully — a partially seated connector is the most common cause of post-repair failure — then restore power and test each burner zone before reassembling.

✓ Model Repair Pages

JIC4536XB00, JIC4536XS00. Contact us to verify your model number before ordering.

💡 Pro Tip