Dishwasher Dead or Won’t Respond? Control Board W11087226 – Fix Unresponsive Panel Fast

If your Whirlpool, Maytag, or KitchenAid dishwasher won’t start, has a dead control panel, stops mid-cycle, or displays error codes, the main control board is the most likely cause. In most Whirlpool-built dishwashers, this is caused by a failed control board. When it fails, the appliance cannot process any cycle commands, respond to button presses, or complete any wash program. ⚡ Common failure point in Whirlpool-platform dishwashers. Part W11087226 is the genuine OEM replacement that restores full electronic control and gets your dishwasher running reliably again.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Dishwasher has power — door latch clicks and registers
• ✔ Door latch, thermal fuse, and water supply have been confirmed OK
• ✔ Control panel lights up but no cycle starts, or panel is completely dead
• ✔ ONLY problem is failure to start, mid-cycle stops, error codes, or unresponsive buttons

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Dishwasher won’t start — no response to any button presses
• Control panel lights up but no cycle begins
• Dishwasher stops mid-cycle and won’t resume
• Error codes displayed on the control panel

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this control board restores normal operation immediately.

📦 Part Details

• Part Number: W11087226
• Type: Main Electronic Control Board / PCB Assembly — manages cycle selection, water temperature, wash timing, drain sequencing, and heated dry
• Replaces: W10919360, W10906426, W10906427, W10906428, W10906429, W10906430
• Brands: Whirlpool, Maytag, KitchenAid, Jenn-Air, Amana, Kenmore

⚙️ Installation

Skill Level: ADVANCED — 60–90 minutes. Disconnect power at the breaker before servicing. Open the door and remove the inner door panel screws (typically 6–8 Torx T20 around the perimeter). Photograph all wire harness connectors before disconnecting, swap the board, reconnect all harnesses per your photos, and reassemble the door panel. Restore power and run a test cycle to confirm operation.

✓ Compatible Models

Confirmed compatible with WDF330PAHB0, WDF330PAHB1, WDF330PAHB2, WDF330PAHB3, WDF330PAHB4, WDF330PAHD0, WDF330PAHD1, WDF330PAHD2, WDF330PAHS0, WDF330PAHS1, WDF330PAHS2, WDF330PAHS3, WDF330PAHS4, WDF330PAHS5, WDF330PAHT0, WDF330PAHT1, WDF330PAHT2, WDF330PAHT3, WDF330PAHT4, WDF330PAHW0, WDF330PAHW1, WDF330PAHW2, WDF330PAHW3, WDF330PAHW4, WDF331PAHB0, WDF331PAHS0, WDF331PAHW0 plus additional Whirlpool-platform models. Contact us to verify your model number before ordering.

💡 Pro Tip