Whirlpool Appliance Electronic Control Board 67006294, Fixes No Power, Won't Start & Control Failures

🇺🇸 Matching U.S. Part Number: 67006294

The Whirlpool 67006294 Electronic Control Board is designed to restore full electronic control function to compatible Whirlpool appliances. It replaces 12939601 when fitment is confirmed by the appliance model number. This part has been discontinued by the manufacturer and is no longer available new from Whirlpool.

Is This the Right Part?

Confirm the complete model number before ordering. Similar control boards may use different connectors, harness positions, or firmware versions.

Common Symptoms

• Appliance completely dead — no power, no display, no response to any input
• Appliance starts but stops mid-cycle or fails to complete a cycle
• Display panel blank or showing error codes that won’t clear after a power reset
• Controls unresponsive or behaving erratically — wrong settings selected or not saving

Check Before Replacing

• Confirm power supply is live — outlet, circuit breaker, and power cord are all good
• Perform a power reset (unplug 60 seconds) to rule out a temporary fault code
• Check all wire harness connectors on the existing board for corrosion or loose pins
• Verify the door latch or lid switch is functional — a faulty switch can mimic a dead control board

Part Details

Installation Notes

1. Disconnect power before servicing.
2. Photograph all wire harness connector positions before disconnecting anything.
3. Compare the new board with the original before installation.
4. Inspect nearby wires and connectors for heat damage or corrosion.
5. Test the appliance and check for error codes after reassembly.

Use a qualified technician when diagnosis or installation is outside your experience.

Verified Compatible Models

Confirm your model number before ordering. Contact us to verify fitment.

Fitment reminder: Match the complete model number, including suffixes and revision digits, before ordering.