Washer Leaking or Not Rinsing Properly? Injector Hose Assembly WP206680 – Fix Water Injection Failures & Leaks Fast

When your top-load washer leaks during the fill or rinse cycle, delivers poor rinse performance, or water isn't injecting correctly into the drum, the injector hose assembly is the most common failed component. In Whirlpool and Maytag top-loading washers, the injector hose assembly routes water from the inlet valve through the nozzle and injector into the tub — when hoses crack, clamps fail, or the injector clogs, water bypasses the drum or leaks at the connection points. ⚡ Common failure point in Whirlpool-platform top-load washers. Part WP206680 is the genuine OEM new-style replacement assembly that restores proper water injection and eliminates leaks — direct fit, no modification required. Supersedes 206680 and 206683.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and agitates/spins normally
• ✔ Water inlet valve is functioning (water enters the machine)
• ✔ Water supply hoses and shutoff valves are confirmed OK
• ✔ Drum and tub seals are intact with no visible damage
• ✔ ONLY problem is leaking at the injector area, poor rinse, or water not reaching the drum correctly

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Water leaking from inside the washer cabinet during fill or rinse — most common complaint
• Clothes not rinsing properly — detergent residue left on fabrics
• Water spraying or misting inside the cabinet instead of flowing into the drum
• Visible cracking, brittleness, or disconnection on the injector hoses
• Hose clamps corroded or no longer holding pressure
• Washer fills but rinse cycle performance is noticeably reduced

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this injector hose assembly restores full wash and rinse performance immediately.

📦 Part Details

• Part Number: WP206680
• Type: Washer injector hose assembly — new style; includes nozzle 213015, injector 216201, sleeve 215447, hose 213013, hose 215234, and 2 hose clamps 202515
• Replaces: OEM direct-fit injector hose assembly — supersedes 206680, 206683 (no modification required). For old style use 204660.
• Brands: Whirlpool, Maytag

⚙️ Installation

Skill Level: MODERATE — 20–35 minutes. Unplug the washer and shut off the water supply before beginning. Access the injector hose assembly by removing the washer cabinet or top panel depending on your model. Disconnect the old hoses at both ends, noting routing and clamp positions, then install the new assembly in reverse order — ensure all clamp positions are secure before reassembly. Run a full wash cycle and inspect for leaks at all connection points before returning the machine to service.

💡 Pro Tip

Browse all parts for your model: LAT8608AAW, LAT8608AAL, LAT8120AAW, LAT8210AAW, LAT9400AAE, LA882, LA884, GA882, GA884, MAT25CSAAW, MAT25CTAAW, MAT26MNAAW, MAT26PCAAW, MAT23PCAAW.