Washer Not Spinning or Agitating? Drive Belt WW01F00345 – Fix Belt Failure Fast

If your GE or Monogram washer runs but the drum won't spin or agitate, a broken or worn drive belt is the most common cause. In most GE top-load and combo washers, the drive belt transfers motor power directly to the drum — when it snaps or stretches, the motor runs but the drum sits still, leaving clothes soaking wet. ⚡ High-wear consumable in GE-built washers — one of the most frequently replaced drive components. Part WW01F00345 is the genuine OEM replacement that restores full spin and agitation immediately, with an exact-fit design requiring zero modification.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and the motor runs audibly
• ✔ Water fills and drains normally
• ✔ Control board shows no unrelated fault codes
• ✔ Lid switch and door latch confirmed functional
• ✔ ONLY problem is drum not spinning or agitating during cycle

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Drum does not spin — motor hums but tub stays still
• Clothes soaking wet at end of spin cycle
• No agitation — drum sits motionless during wash
• Burning rubber smell during or after cycle
• Loud squealing or slipping noise when cycle starts
• Visible belt debris or broken belt found inside cabinet

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this drive belt restores normal spin and agitation immediately.

📦 Part Details

• Part Number: WW01F00345
• Type: Washer Drive Belt — OEM direct-fit drum/agitator drive component
• Replaces: 228C2115P002, 228C2115P003, 228C2115P004, WH1M1073 (no modification required)
• Brands: GE, Monogram

⚙️ Installation Notes

Skill Level: MODERATE — 30–45 minutes. Disconnect power before beginning. Access the drive belt by removing the washer cabinet or rear panel depending on your model; route the new belt around the motor pulley and drum/transmission pulley per the original path. Ensure the belt seats fully in both pulley grooves before reassembling — an off-track belt will snap again within one cycle.

💡 Pro Tip

Find all parts for your model: BBRE1065H0WW parts hub, GJXE1065H0WW parts hub, GJXR1065F00WW parts hub, GUAN275ED1WW parts hub, GUAN275ED2WW parts hub, GUAP240EM5WW parts hub, GUAP270EM2WW parts hub, GUAP270EM4WW parts hub, GUD24ESMJ0WW parts hub, GUD27ESMJ0WW parts hub, GUD27ESMJ1WW parts hub, GUD37ESMJ0DG parts hub, GUD37ESMJ1DG parts hub, MERE1065H0WW parts hub, MESE1065H0WW parts hub, MESR1065F00WW parts hub, MEXE1045H0WW parts hub, MEXE1055H0WW parts hub, MEXR1055F00WW parts hub, MHDSE165H0WW parts hub, MHDSR165F00WW parts hub, MHDXE145H0WW parts hub, MHDXR145F00WW parts hub, ZISS360NRSS parts hub

✓ Model-Specific Repair Pages