BURNER WILL NOT IGNITE OR DOES NOT PRODUCE A STABLE FLAME
Whirlpool Range Sealed surface burner assembly / sealed burner head with spark electrode WP3412D024-09, Fixes Burner will not ignite or does not produce a stable flame
Black sealed gas surface-burner head assembly with an integrated spark electrode. It directs gas flow and supports even flame distribution on a gas range. The manufacturer parts listing states that no gasket seal is required and that the assembly releases by rotating counterclockwise.
Part WP3412D024-09Replaces 3412D024-09Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberWP3412D024-09
Replaces3412D024-09
ManufacturerWhirlpool
Appliance TypeRange
Part TypeSealed surface burner assembly / sealed burner head with spark electrode
✅ Cross Reference Information
Current Part NumberWP3412D024-09
Replaces3412D024-09
Common Symptoms
- A burner fails to light despite the range’s ignition system operating
- Uneven or unstable flame distribution from the affected burner
- Gas odor associated with a burner that does not ignite
- Burner ignition or flame performance remains abnormal after confirming the burner components are correctly seated
Check Before Replacing
- Turn all burner controls off and allow the burner to cool before inspection.
- Confirm the burner head is correctly seated and has not shifted out of position.
- Visually inspect the burner head, gas ports, and integrated electrode for cracks, blockage, contamination, or visible damage; do not probe or enlarge the ports.
- Compare the affected burner’s visible flame behavior with another burner, while following the appliance owner’s safety instructions.
- If gas odor persists when the controls are off, stop using the appliance, ventilate the area if safe, and contact a qualified gas-appliance service professional.
Pro Tip
Before replacing the assembly, verify that the burner head is seated correctly and that the ports and electrode area are clean and unobstructed; the updated Whirlpool assembly does not require a gasket seal.
Part Details
Part NumberWP3412D024-09
Part TypeSealed surface burner assembly / sealed burner head with spark electrode
ManufacturerWhirlpool
Appliance TypeRange
Primary FunctionDirects and evenly distributes gas to the range’s sealed surface-burner ports while supporting ignition through its integrated spark electrode.
Installation Notes
- Disconnect electrical power and allow the appliance and burner components to cool before service.
- Remove the grate and other removable burner components as needed to access the assembly.
- Follow the manufacturer’s specified rotation direction to release the old assembly; the Whirlpool listing specifies counterclockwise release.
- Transfer or reconnect the spark/electrode connection only as directed by the appliance’s service information, keeping wires from falling into the range top.
- Seat and lock the replacement assembly as directed, and do not add a gasket seal because the updated part is specified not to require one.
- After installation, check operation only after all parts are correctly seated; if gas odor or abnormal flame persists, discontinue use and obtain qualified service.
Verified Compatible Models
A8241RA, A8241RS, A8241RV, A8241RW, CSG5600BAD, CSG5600BAL, CSG5600BAW, D8241RT-L, X8261RB, X8261RV
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
