Is your dryer running but not producing heat? This is one of the most common dryer problems, and the good news is it's usually an easy DIY fix with the right replacement part. XPart Supply stocks all the heating components you need for Whirlpool, Maytag, GE, Kenmore, LG, Samsung, and other major brands.
Symptoms: Dryer runs but produces no heat at all, or heat is inconsistent.
Solution: Replace the heating element. This is the #1 cause of no-heat issues in electric dryers.
Popular Parts:
Symptoms: Dryer won't heat at all. The thermal fuse is a safety device that cuts power to the heating element if the dryer overheats.
Solution: Replace the thermal fuse. Once blown, it cannot be reset and must be replaced.
Popular Parts:
Symptoms: Dryer heats intermittently or takes too long to dry clothes.
Solution: Replace the cycling thermostat. This regulates the temperature inside the dryer drum.
Symptoms: Gas dryer won't heat. You may hear the igniter clicking but no flame.
Solution: Replace the gas valve solenoid coils or the complete gas valve assembly.
Symptoms: Gas dryer won't ignite. The igniter should glow bright orange before the gas valve opens.
Solution: Replace the igniter if it's weak, cracked, or not glowing.
Need a replacement instead of a repair?
Sometimes the repair cost isn’t worth it. XPart Supply carries Certified Pre-Owned washers and dryers that have been inspected, repaired, cleaned, and tested — available for local pickup or in-town delivery in Kitchener, Waterloo, Cambridge, Guelph, Brantford, and Hamilton.
View Certified Pre-Owned AppliancesThe most common causes are a faulty heating element (electric dryers), blown thermal fuse, bad cycling thermostat, or failed gas valve/igniter (gas dryers). Start by checking the thermal fuse and heating element.
Use a multimeter to test for continuity. If there's no continuity, the heating element is broken and needs replacement. You may also see visible breaks or damage in the coil.
Yes! Replacing a heating element is a common DIY repair. You'll need basic tools (screwdriver, nut driver, multimeter) and about 30-60 minutes. Our parts specialists can guide you through the process.
A thermal fuse blows due to overheating, usually caused by a clogged dryer vent, restricted airflow, or a faulty cycling thermostat. Always clean your vent system and check the thermostat when replacing a thermal fuse.
DIY parts typically cost $20-$150 depending on the component. Heating elements run $30-$80, thermal fuses $10-$25, and thermostats $15-$40. Professional repair can cost $150-$400+ including labor.
View Full Parts Guide & Repair Tips →
