Washer Drum Not Spinning? Drive Motor 0124000570 – Fix No-Spin Fast

A failed drive motor is the most common reason a Bosch or Siemens front-load washer stops spinning or agitating entirely. In most BSH-built washers, the drive motor powers the drum directly — when it fails, the drum won't rotate, clothes come out soaking wet, or the machine throws a motor-related fault code and stops mid-cycle. ⚡ Common failure point in Bosch-built front-load washers. Part 0124000570 is the direct-fit OEM replacement that restores full drum function with no modification required.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your washer powers on and fills with water normally
• ✔ The drum does not spin or agitate on any cycle
• ✔ Water supply and drain hoses are confirmed clear and functional
• ✔ Door latch and lid switch are functioning correctly
• ✔ ONLY problem is drum not rotating — control board and wiring harness are intact

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Drum does not spin or rotate on any wash or spin cycle
• Clothes come out soaking wet after a full cycle
• Washer hums or buzzes but drum does not move
• Machine stops mid-cycle and displays a motor fault code
• Error codes E01, F21, or motor-related fault displayed on panel
• Burning smell from motor area during attempted spin

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this drive motor restores normal washer operation immediately.

📦 Part Details

• Part Number: 0124000570
• Type: Front-Load Washer Drive / Drum Motor
• Replaces: OEM direct-fit motor assembly — supersedes 00124000570 (no modification required)
• Brands: Bosch, Siemens, Gaggenau, Neff (BSH Group)

⚙️ Installation

Skill Level: Advanced — 60–90 minutes. Disconnect power and water supply before beginning. Access requires removing the rear panel or front panel depending on model — the motor is mounted directly to the drum bearing housing. Disconnect the wiring harness, remove the mounting bolts, swap the motor, and reassemble in reverse order. Torque mounting bolts to spec and ensure the harness connector is fully seated before restoring power.

✓ Compatible Models

Confirmed compatible with select Bosch, Siemens, Gaggenau, and Neff front-load washer models. Contact us to verify your model number before ordering.

💡 Pro Tip

See all parts, cross-references, and model compatibility: 0124000570 Part Hub, 00124000570