Miele Washer Drain Pump 11001011001329 – OEM Replacement
The 11001011001329 is the OEM Miele washer drain pump, responsible for evacuating water from the drum at the end of each wash and spin cycle. When this pump fails, the washer will not drain, leaving clothes sitting in standing water and preventing the cycle from completing. This direct-fit replacement restores full drain function without modification.
Miele Washer Washer Parts and Accessory 11001011001329
Is This the Right Part?
Confirm the complete model number before ordering. Similar parts may use different connectors, dimensions, hose positions, electrical ratings, or mounting points.
Part Details
Installation Notes
- Disconnect power and shut off water or gas where applicable.
- Photograph wiring, hoses, clamps, and mounting positions.
- Compare the new part with the original before installation.
- Inspect nearby wires, hoses, seals, and connectors for damage.
- Test the appliance and check for leaks, unusual sounds, or error codes.
Use a qualified technician when diagnosis or installation is outside your experience. Gas parts should be installed by a licensed technician.
Verified Compatible Models
MLH27N5AWWC, MLC31N5AWW, CLC27N3AWW, MLH25N7BWW, MLH27N4AWWC, MLC27N3AWW, MLC31N4AWW
Fitment reminder: Match the complete model number, including suffixes and revision digits, before ordering.
Don’t see your model? Contact us
Washer not draining at end of cycle — Standing water remaining in drum after wash — Washer stops mid-cycle with water in tub — F11 or drain error codes displayed — Unusual humming or grinding noise during drain phase — Washer door won’t unlock after cycle (due to water remaining)
OEM Miele part — guaranteed fit for compatible models. Direct replacement — no modification required. Evacuates wash water efficiently at end of each cycle. Compatible with Miele front-load washer and washer-dryer combo units in the MLH, MLC, and CLC series.
New OEM (Part #11001011001329): Genuine Miele replacement drain pump. Full manufacturer specifications and expected service life. Recommended for all repairs.
XPart Supply aftermarket replacement parts are not affiliated with, sponsored by, or endorsed by Miele or any OEM manufacturer.
11001011001329 (OEM Miele drain pump — no known superseding part number on file).
Disconnect power and water supply before beginning. The drain pump on Miele front-load washers is typically accessed through the lower front service panel. Place towels and a shallow pan to catch residual water before disconnecting the pump hoses. Disconnect the wiring harness, remove the mounting screws or twist-lock, and swap the pump. Reconnect hoses and wiring, restore power, and run a drain/spin cycle to confirm proper operation. Check for leaks at all hose connections after installation.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
