Midea Washer Up Drain Hose Assembly 12138000031261, Replaces 12138000009819, 301121670012

Genuine Midea up drain hose assembly for compatible top-load washing machines. The hose routes wastewater from the washer tub toward the drain standpipe or laundry sink.

Is This the Right Part?

Common Symptoms

• Water leaking from the rear or underside of the washer during a drain cycle
• Washer drains slowly or does not drain completely when the hose is kinked, clogged, or damaged
• Visible cracks, splits, holes, brittleness, or collapse in the drain hose
• Washer draining or spinning problems caused by improper hose position or excessive drain height
• Water siphoning or backflow caused by incorrect hose insertion or routing

Check Before Replacing

• Unplug the washer before inspecting the hose or moving the appliance.
• Visually inspect the accessible hose for kinks, crushing, cracks, splits, holes, brittleness, or collapsed sections.
• Confirm the hose is securely connected at its accessible connection points and is not being pinched by the washer or wall.
• Check that the household standpipe or drain accepts water freely; do not assume a washer hose is defective if the household drain is blocked.
• Verify that the hose routing and drain height follow the washer's model-specific installation instructions and that the hose is not inserted too deeply into the drain.

Pro Tip

Part Details

Key Features

• Genuine Midea replacement component
• Up drain hose assembly for compatible Midea top-load washers
• Part number 12138000031261
• Designed to provide the washer's wastewater discharge path
• Exact fit and connection details must be confirmed against the complete washer model number

Installation Notes

• Disconnect electrical power before servicing and use care because residual water may remain in the hose.
• Document the original hose routing before removal so the replacement follows the same path.
• Avoid sharp bends, kinks, crushing, or pinching when positioning the replacement hose.
• Reconnect the hose securely at the designated connection points and verify the drain routing and height against the washer's model-specific instructions.
• After installation, run an appropriate drain or rinse test and inspect the hose connections and surrounding area for leaks before returning the washer to normal use.

Verified Compatible Models

ATLMW41, CLAWI47W, CTW41N1AW, CTW45N1AW, CTW45N2AW, LT52N1BWWC, LT52N1BWWCFR, MLV41N1AWW, MLV41N1AWWC, MLV45N1BWW, MLV45N1BWWC, MLV45N3BMG, MLV45N3BWW, MLV47A3AGG, MLV47C3AWW

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.