FREEZER DOOR DOES NOT SEAL OR CLOSE PROPERLY
Midea Refrigerator Freezer Door Assembly 12831000038634, Fixes Freezer door does not seal or close properly
Genuine Midea freezer door assembly used on specified Insignia single-door refrigerator and Midea upright freezer models.
Part 12831000038634Replaces 12831000016243Midea
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part Number12831000038634
Replaces12831000016243
ManufacturerMidea
Appliance TypeRefrigerator
Part TypeFreezer Door Assembly
✅ Cross Reference Information
Current Part Number12831000038634
Replaces12831000016243
Common Symptoms
- Frost or ice buildup around the freezer-door perimeter
- Freezer temperature inconsistency associated with air leakage at the door
- Door misalignment, looseness, or difficulty opening and closing
Check Before Replacing
- Visually inspect the door perimeter for gaps, warped areas, tears, or other damage.
- Close the door and check whether the gasket makes continuous contact with the cabinet around the full perimeter.
- Check for frost patterns concentrated near the door seal, while considering other possible causes before replacing the door.
- Observe whether the door sits squarely and closes without rubbing or remaining partially open.
- Verify the appliance model number and compare the replacement door’s appearance and orientation before ordering or installing.
Pro Tip
A door-related temperature problem is often caused by gasket contact, hinge alignment, or an obstruction; inspect these areas before concluding that the complete door assembly requires replacement.
Part Details
Part Number12831000038634
Part TypeFreezer Door Assembly
ManufacturerMidea
Appliance TypeRefrigerator
Primary FunctionProvides the complete freezer-door barrier for the refrigerator/freezer compartment, supporting proper closure and sealing to retain cold air.
Installation Notes
- Disconnect appliance power before service and protect the cabinet and door surfaces during handling.
- Confirm the replacement assembly matches the original door’s orientation, finish, handle arrangement, and hinge-side configuration before removing the original.
- Support the door during removal and installation; a complete door assembly may be bulky or heavy.
- After installation, verify that the door is level, closes freely, and produces continuous gasket contact before restoring normal operation.
- Follow the appliance-specific service documentation for any hinge, handle, or hardware transfer procedures; those details were not verified for this exact part.
Verified Compatible Models
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
