Washer Leaking or Not Draining? Tub-to-Pump Hose 134639910 — Fix Drainage Failures Fast
If your Frigidaire or Electrolux front-load washer is leaking from the bottom or failing to drain, the tub-to-pump hose is the most common culprit. In most Frigidaire-built front-loaders, this is caused by a failed or cracked tub-to-pump hose. When it fails, water pools under the machine, the drum won't empty, and error codes related to drainage appear on the display. ⚡ Common failure point in Frigidaire and Electrolux front-load washers. Part 134639910 is the genuine OEM replacement that restores proper water flow from the drum to the drain pump, eliminating leaks and drainage errors immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your washer powers on and the drum spins normally
- ✔ The water inlet and fill cycle work correctly
- ✔ Your home's drain line and standpipe are confirmed clear
- ✔ ONLY problem is water leaking from the bottom or the washer not draining
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Water pooling or dripping under the front of the washer
- Washer stops mid-cycle with a drain error (E21, E24, or similar)
- Drum fills but will not empty at end of cycle
- Visible cracks, splits, or soft spots on the existing hose
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this tub-to-pump hose restores normal operation immediately.
📦 Part Details
- Part Number: 134639910
- Type: Washer Tub-to-Pump Drain Hose — OEM Frigidaire / Electrolux
- Replaces: 134639910, 131763310 (check cross-reference before ordering)
- Brands: Frigidaire, Electrolux, White-Westinghouse
While the washer is pulled out and the pump access panel is open, inspect the drain pump filter and pump-to-drain hose for debris or wear — replacing a clogged filter at the same time prevents a repeat service call and takes under 5 minutes.
⚙️ Installation
Skill Level: MODERATE — 30–45 minutes. Disconnect power and water supply before servicing. Remove the front access panel or tilt the machine back to access the pump area; release the hose clamps on both ends of the old hose, slide the new hose into position, and secure clamps firmly before running a test cycle to confirm no leaks.
✓ Compatible Models
Confirmed compatible with EIFLS60JIW0, EIFLS60LSS0, EWFLS70JIW0, EWFLS70JSS0, FAFS4174NW0, FAFS4474LW0, 41741100000, 41744130000 plus additional Frigidaire and Electrolux front-load models. Contact us to verify your model number before ordering.
💡 Pro Tip
Over time, the factory spring clamps on Frigidaire front-loaders lose tension and are a secondary cause of leaks even with a new hose installed. Swap them for screw-type hose clamps ($2 each) while you're in there — it's a 30-second upgrade that eliminates the most common callback on this repair.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
