Dryer Squealing or Thumping? 134715900 Drum Roller – Now Superseded by 5304523155

If your Frigidaire or Electrolux dryer is making a squealing, thumping, or grinding noise, the drum roller is the most likely culprit — but note that part 134715900 has been superseded by the current OEM part 5304523155. In most Frigidaire-built dryers, the drum roller wheel assembly supports the rear of the drum as it rotates — when it wears flat or seizes, it creates rhythmic noise and puts strain on the drive belt and motor. ⚡ Common wear failure in Frigidaire and Electrolux electric dryers. Part 134715900 directly replaces 7134715900 and has itself been superseded by 5304523155 — the current OEM replacement.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Dryer powers on and heats normally
• ✔ Drive belt is intact and not broken
• ✔ Motor runs and drum attempts to spin
• ✔ Noise is consistent and rhythmic — not a single bang or electrical sound
• ✔ ONLY problem is squealing, thumping, squeaking, or drum wobble during the cycle

Not sure? Send us your model number — we'll confirm the current part before you order.

🔧 Common Symptoms

• Loud squealing or squeaking noise during the drying cycle — most common complaint
• Rhythmic thumping or bumping as the drum rotates
• Drum wobbling or vibrating excessively during operation
• Visible flat spots or cracking on the roller wheel
• Drum rotating unevenly or dragging on the rear bulkhead
• Drive belt wearing prematurely due to uneven drum support

✔ If these symptoms match, the drum roller is the most likely failed component in the system.

✔ We recommend ordering the current OEM part 5304523155 for guaranteed fit and full lifespan.

📦 Part Details

• Part Number: 134715900 (superseded — current OEM is 5304523155)
• Type: Dryer drum roller wheel assembly — rear drum support roller
• Replaces: 7134715900 (no modification required)
• Superseded by: 5304523155
• Brands: Frigidaire, Electrolux, Gibson, Kenmore, White-Westinghouse

⚙️ Installation

Skill Level: MODERATE — 30–45 minutes. Unplug the dryer before beginning any repair. Drum rollers are located at the rear of the dryer drum and require removing the back panel for access. Lift the drum out, remove the worn roller from its shaft, press the new roller onto the shaft until fully seated, then reassemble in reverse order. Ensure the drum sits evenly on both rollers before reinstalling the back panel.

💡 Pro Tip