WATER LEAKING FROM THE WASHER DRAIN HOSE AREA
Electrolux / Frigidaire Washer drain hose, one piece 137003400, Fixes Water leaking from the washer drain hose area
Genuine OEM one-piece drain hose that carries used water from the washer to the household drain.
Part 137003400Replaces 5304472309, 7137003400Electrolux / Frigidaire
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part Number137003400
Replaces5304472309, 7137003400
ManufacturerElectrolux / Frigidaire
Appliance TypeWasher
Part TypeWasher drain hose, one piece
✅ Cross Reference Information
Current Part Number137003400
Verified Previous OEM Numbers5304472309, 7137003400
Common Symptoms
- Visible water leak during draining or spinning
- Washer drains slowly when the hose is kinked or restricted
- Washer may not drain if the hose is blocked or severely damaged
- Drain water misses the standpipe or laundry tub if the hose is loose or unsecured
Check Before Replacing
- Unplug the washer before inspecting accessible hose areas.
- Visually inspect the hose for kinks, splits, cracks, loose connections, or wetness during a drain cycle if safe to observe externally.
- Confirm the hose is not inserted or sealed too tightly into the standpipe and that the household drain is not clogged.
- Verify the drain hose is secured so it cannot pull out of or miss the standpipe or laundry tub.
- Do not conclude the hose is defective until the household drain and washer drain pump are also considered.
Pro Tip
A slow-draining washer is not always caused by the hose: straighten kinks, check the household drain, and preserve an air path at the standpipe before replacing the hose.
Part Details
Part Number137003400
Part TypeWasher drain hose, one piece
ManufacturerElectrolux / Frigidaire
Appliance TypeWasher
Primary FunctionCarries used wash and rinse water from the washer drain pump to the household standpipe or laundry tub.
Installation Notes
- Disconnect electrical power before service.
- Route the replacement hose without kinks, pinching, or sharp bends.
- Secure the external drain end so it cannot come loose or discharge outside the standpipe or laundry tub.
- Do not create an airtight seal around the standpipe; the standpipe requires an air path for proper draining.
- Use the model-specific service documentation for access and internal connection details; the access procedure can vary by washer model.
Verified Compatible Models
Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
