Electrolux / Frigidaire Dryer inlet thermal limiter (non-resettable thermal fuse) 137032600, Replaces 137060800, 7137032600

OEM dryer inlet thermal limiter that shuts off the heater when the dryer overheats. The part is also cataloged as a non-resettable thermal fuse and is used in some washer-dryer laundry centers.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Dryer may not start when the limiter is in the motor or control safety circuit.
• Dryer may tumble but produce no heat when the limiter interrupts the heating circuit.
• Dryer may stop during a cycle and fail to restart after an overheating event.
• Repeated limiter failure may be associated with restricted exhaust airflow, lint buildup, or another heating-system fault.

Check Before Replacing

• Disconnect power before accessing or testing the limiter.
• With the limiter electrically isolated as specified by the model’s service information, check continuity across its terminals with a multimeter.
• A working limiter should show continuity or very low resistance; an open reading indicates the limiter has opened.
• Inspect and clear lint accumulation and verify that the exhaust duct is not crushed, blocked, or restricted before installing another limiter.
• If the limiter is open, inspect related components such as the heater, high-limit thermostat, thermistor, wiring, and exhaust airflow rather than assuming the limiter is the only fault.
• Never bypass or short the limiter for operation.

Pro Tip

Part Details

Key Features

• Frigidaire/Electrolux OEM thermal limiter for selected dryers and laundry centers.
• Non-resettable, single-use safety component.
• Designed to interrupt the protected circuit when excessive temperature is reached.
• Cataloged under the exact manufacturer part number 137032600.
• Documented replacement numbers include 137060800 and 7137032600.

Installation Notes

• Disconnect the dryer from electrical power before servicing.
• Use the appliance’s model-specific service documentation to locate the limiter and determine the required access procedure.
• Photograph or label wire connections before removal, then reconnect them to the same terminals.
• Install only the exact limiter specified for the appliance; temperature ratings, terminal layout, and mounting arrangement must match.
• After installation, reassemble all removed panels and verify that exhaust airflow is clear before testing the dryer.
• Do not reuse, reset, bypass, or bridge the removed limiter.

Verified Compatible Models

41761712510, 41761712511, 41761722510, 41761722511, 41761723510, 41761723511, 41761732810, 41761732811, 41761733810, 41761733811, 41771712510, 41771712511, 41771712512, 41771722510, 41771722511

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.