WASHER DOES NOT DRAIN OR LEAVES WATER IN THE TUB
Electrolux Washer Drain Pump - 120V 60Hz 137038700, Fixes Washer does not drain or leaves water in the tub
Genuine Electrolux/Frigidaire washer drain pump. It removes water from the washer during the drain portion of the cycle.
Part 137038700Replaces 7137038700Electrolux
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part Number137038700
Replaces7137038700
ManufacturerElectrolux
Appliance TypeWasher
Part TypeDrain Pump - 120V 60Hz
✅ Cross Reference Information
Current Part Number137038700
Replaces7137038700
Common Symptoms
- Slow or incomplete draining
- Clothes remain unusually wet because drain water is not fully removed
- Humming or grinding during the drain portion of the cycle
- Water remaining in the tub at the end of the cycle
Check Before Replacing
- Disconnect electrical power before inspecting the pump area or wiring.
- Check the washer drain hose for visible kinks, crushing, or blockage.
- If the washer design provides an accessible drain filter or pump inlet, inspect and clean it according to the model’s instructions.
- During a drain operation, listen for pump operation; no sound, unusual noise, or weak water flow can indicate a drainage-system problem, but does not by itself confirm pump failure.
- Visually inspect the pump wiring connector and hoses for looseness, damage, or leakage without applying power while exposed.
Pro Tip
Before replacing the pump, rule out a blocked drain hose, pump inlet, or filter; restricted drainage can produce symptoms that resemble a failed pump.
Part Details
Part Number137038700
Part TypeDrain Pump - 120V 60Hz
ManufacturerElectrolux
Appliance TypeWasher
Primary FunctionPumps wastewater out of the washer during the drain portion of the cycle.
Installation Notes
- Disconnect the washer from electrical power before installation.
- Drain or otherwise contain residual water before disconnecting pump hoses.
- Disconnect the pump electrical connector and hoses only after power is removed.
- Install the replacement pump in the same orientation and routing as the original, and ensure hose and electrical connections are fully seated.
- Use the appliance’s model-specific service or installation instructions because access and mounting details vary by washer model.
- Check for leaks and proper draining after reassembly before returning the washer to normal use.
Verified Compatible Models
EIFLW55HIW0, EIFLW55HMB0, EIFLW55IKG0, EIFLW55IRR0, EWFLS65IIW0, EWFLS65IMB0, EWFLS65IRR0, EWFLS65ISS0, EWFLS65ITS0, EWFLW65HIW0, EWFLW65HSS0, EWFLW65HTS0, EWFLW65IMB0, EWFLW65IRR0, FAH105N2T, FAH105N2T2, FAH106N2T1, FAH124N2T, FAH125N2T, FAH125N2T1, FAH125N2T2, FAH126N2T1
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
