Dishwasher Won’t Start or Stuck Mid-Cycle? Control Board 1755700600 — Restore Full Program Control Fast
A dishwasher that won’t start, stops mid-cycle, or runs the same cycle repeatedly almost always has a failed main control board. In most Bosch-built dishwashers, the control board is the central processing unit that manages every wash function — from water intake and heating to pump operation, cycle sequencing, and error code detection. When it fails, the dishwasher may appear dead, get stuck in a loop, or throw persistent error codes that can’t be cleared. ⚡ Common failure point in Bosch-platform dishwashers. Part 1755700600 is the genuine OEM replacement that restores full electronic control and normal wash cycle operation.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Dishwasher has power — door latch and water supply confirmed OK
- ✔ Error codes persist after power cycling (E-series codes on Bosch)
- ✔ Door switch, thermal fuse, and pump have been confirmed functional
- ✔ ONLY problem is failure to start, mid-cycle stoppage, or unresponsive controls
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Dishwasher will not start any cycle despite door being latched
- Cycle stops partway through and will not resume
- Persistent error codes (E01, E09, E15, E24, etc.) that cannot be cleared
- Control panel buttons respond but dishwasher does not execute commands
- Dishwasher runs continuously without completing or draining
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this control board restores full wash cycle operation immediately.
📦 Part Details
- Part Number: 1755700600
- OEM Reference: 00-1755700600
- Type: Main Electronic Control Board (PCB)
- Brands: Bosch, Thermador, Gaggenau
While the control board is out, inspect the door latch assembly and thermal fuse. A failed thermal fuse can mimic a dead control board — and a faulty door latch can cause repeated board failures by sending incorrect door-closed signals. Replacing these at the same time protects your new board.
⚙️ Installation
Skill Level: Moderate — 30–45 minutes. Disconnect power before servicing. Remove the inner door panel to access the control board mounted behind the control console. Photograph all wire harness connections before disconnecting, swap the board, reconnect all connectors, and reassemble the door panel. Restore power and run a diagnostic cycle to confirm all functions are operational.
✓ Compatible Models
Confirmed compatible with SHE3AR72UC, SHE3AR75UC, SHE5AM06UC, SHE5AM16UC, SHE7PT55UC, SHE7PT56UC, and additional Bosch, Thermador, and Gaggenau dishwasher models. Contact us to verify your model number before ordering.
💡 Pro Tip
Bosch dishwashers have a built-in diagnostic mode that can be activated by pressing and holding specific button combinations (varies by model — check your service manual). Running diagnostics immediately after board replacement confirms all sensors and components are communicating correctly with the new board, and will surface any secondary faults before the unit is returned to service.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
