Washer Not Advancing Through Cycles? Control Timer 20056314A – Fix Cycle Failure Fast
When your washer gets stuck in a cycle, won't advance, or stops mid-wash, the control timer is almost always the culprit. In most top-load washers, this is caused by a failed control timer. When it fails, the washer may stop mid-cycle, skip cycles entirely, refuse to spin or agitate, or simply not respond to the cycle selector. ⚡ Common failure point in Whirlpool, Maytag, and Kenmore top-load washers. Part 20056314A is the genuine OEM replacement that restores proper cycle sequencing and full washer operation.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your washer powers on and fills with water normally
- ✔ The lid switch, motor, and pump are confirmed working
- ✔ Water supply and inlet valves are confirmed OK
- ✔ ONLY problem is the washer not advancing, cycling, spinning, or agitating correctly
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Washer stuck in one cycle and won't advance
- Washer stops mid-cycle with water still in the drum
- Agitator or spin cycle not engaging
- Cycle selector knob turns but washer doesn't respond correctly
- Washer completes fill but never moves to wash or rinse
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this control timer restores normal cycle operation immediately.
📦 Part Details
- Part Number: 20056314A
- Type: Washer Control Timer – Cycle Sequencing Module
- Brands: Whirlpool, Maytag, Kenmore
- Condition: OEM New or Certified Used (select variant above)
While the control panel is open, inspect the cycle selector switch and wiring harness for corrosion or burnt contacts. A failed timer often stresses surrounding components — replacing a worn selector switch at the same time prevents a repeat service call.
⚙️ Installation
Skill Level: Moderate — 30–45 minutes. Disconnect power before servicing. Remove the control panel by releasing the retaining clips or screws at the rear, unplug the wiring harness from the old timer, and transfer the knob and bracket to the new unit before reinstalling. Refer to your model's wiring diagram to ensure correct harness reconnection.
✓ Compatible Models
Confirmed compatible with select Whirlpool, Maytag, and Kenmore top-load washer models. Contact us to verify your model number before ordering.
💡 Pro Tip
Control timers have multiple wire terminals that look similar. Before unplugging anything, take a clear photo of the harness connections on the old timer. This makes reinstallation on the new unit fast and error-free — and eliminates the most common cause of a "new timer, same problem" callback.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
