Menu
Oven Burner Not Responding? Burner Switch 204816-1080 – Fix Burner Control Fast
A burner that won't turn on, won't shut off, or is stuck on a single heat setting points directly to a failed burner switch. In most ranges and ovens, the burner switch is the primary control component that regulates power to each surface element. When it fails, the burner may not respond to the dial, remain on continuously, or produce only one heat level regardless of the setting. ⚡ Common failure point in electric ranges and ovens. Part 204816-1080 is the genuine OEM replacement switch that restores full burner control and proper heat regulation.
⚠️ This part is No Longer Available (NLA) from the manufacturer. The unit listed here is a used/pull OEM part. Inspect photos carefully and contact us with any questions before ordering.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ QUALIFIER 1 — Appliance powers on and other burners work normally
- ✔ QUALIFIER 2 — The affected burner does not respond to the control dial
- ✔ QUALIFIER 3 — Wiring and element have been confirmed OK
- ✔ ONLY problem is the specific burner failing to cycle or control heat
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Burner won't turn on at any setting
- Burner stays on continuously and won't shut off
- Burner only works on one heat level (e.g., always high)
- Dial turns but burner does not respond
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this burner switch restores normal operation immediately.
📦 Part Details
- Part Number: 204816-1080, INF-240P-C632
- Type: Oven / Surface Burner Infinite Switch
- Condition: Used OEM Pull — NLA (No Longer Available New)
- Application: Electric Range / Oven Burner Control
⚠️ Recommended While Repairing:
Inspect the burner element and wiring harness while the switch is out — if the element shows pitting or the wiring shows heat damage, replace those at the same time to avoid a repeat service call.
Inspect the burner element and wiring harness while the switch is out — if the element shows pitting or the wiring shows heat damage, replace those at the same time to avoid a repeat service call.
⚙️ Installation
Skill Level: MODERATE — 30–60 minutes. Disconnect power before servicing. Remove the control knob and panel to access the switch. Disconnect the wiring harness, swap the switch, reconnect wires in the same configuration, and reassemble. Test on all heat settings before closing up.
✓ Compatible Models
Confirm compatibility using your full model number. Contact us to verify your model number before ordering — this is an NLA part and all sales are final.
💡 Pro Tip
NLA Part — Act Fast:
This part is no longer manufactured. Once our used stock is gone, it will not be restocked. If you have a second unit of the same appliance or a known-failing switch, consider ordering a spare now while stock lasts.
This part is no longer manufactured. Once our used stock is gone, it will not be restocked. If you have a second unit of the same appliance or a known-failing switch, consider ordering a spare now while stock lasts.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
