Whirlpool Dryer Gas Valve Solenoid Coil Kit 279834, Fixes Dryer runs but does not heat
Gas dryer valve solenoid coil kit containing one two-terminal coil and one three-terminal boost/hold coil.
Confirm your full appliance model number before ordering.
Is This the Right Part?
✅ Cross Reference Information
Common Symptoms
- No heat despite a glowing igniter
- Intermittent heating
- Igniter glows and then shuts off without burner ignition
- Dryer heats initially but stops heating after the coils warm up
Check Before Replacing
- Observe the burner through the inspection area during a heat cycle; if the igniter glows but the burner does not ignite, the coils may be defective.
- If heating is intermittent, observe whether the burner operates when the dryer is cold but fails after repeated heating cycles.
- Verify that the dryer uses a compatible two-coil M-style gas valve before ordering.
Pro Tip
Part Details
Installation Notes
- Disconnect electrical power before servicing.
- Shut off the dryer gas supply before service.
- Use the appliance-specific service information for panel removal, coil orientation, and final testing.
Verified Compatible Models
Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
