Dishwasher Making Grinding Noise? Front Shaft Bearing Assembly 2973101100 – Fix Bearing Wear Fast

When your Electrolux or Frigidaire dishwasher develops a grinding, squealing, or rumbling noise during the wash cycle, the front shaft bearing assembly is the most common failed component. In most Electrolux-platform dishwashers, the front shaft bearing supports the pump and motor shaft — when it wears out, metal-on-metal contact creates noise, increases vibration, and eventually causes the pump shaft to seize or wobble, damaging surrounding components. ⚡ A common wear item in Electrolux-built dishwashers as the unit ages. Part 2973101100 is the genuine OEM replacement that restores smooth, quiet shaft rotation and protects the pump assembly from further damage.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Dishwasher powers on and fills with water normally
• ✔ Wash cycle runs but produces grinding, squealing, or rumbling noise
• ✔ Noise is coming from the pump/motor area at the base of the unit
• ✔ Spray arms and water circulation are still functioning
• ✔ ONLY problem is abnormal noise or vibration during wash cycle

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Dishwasher making loud grinding or rumbling noise during wash cycle — most common complaint
• Squealing or screeching sound from the base of the dishwasher
• Increased vibration felt through the door or floor during operation
• Noise worsens progressively over multiple cycles
• Pump shaft wobble causing reduced water pressure to spray arms
• Dishwasher leaking from the pump area due to shaft seal damage caused by bearing wear

✔ If these symptoms match, this is the most likely failed component in the pump drive system.

✔ In most cases, replacing this bearing assembly eliminates noise and restores smooth, quiet operation immediately.

📦 Part Details

• Part Number: 2973101100
• Type: Dishwasher front shaft bearing assembly — pump/motor shaft support
• Replaces: OEM direct-fit bearing assembly for Electrolux-platform dishwashers (no modification required)
• Brands: Electrolux, Frigidaire, AEG

⚙️ Installation

Skill Level: ADVANCED — 60–90 minutes. Disconnect power at the breaker and shut off the water supply before beginning. The front shaft bearing assembly is accessed by pulling the dishwasher out and removing the lower pump housing — the unit may need to be laid on its back or side for access. Remove the pump assembly, extract the worn bearing, press or seat the new bearing assembly into position, and reassemble in reverse order. Restore power and water, then run a full wash cycle to confirm quiet operation and no leaks.

✓ Compatible Models

Part 2973101100 is compatible with select Electrolux, Frigidaire, and AEG dishwasher models. Contact us with your model number to confirm compatibility before ordering — we'll verify the fit before you purchase.

💡 Pro Tip