ONE OR MORE SURFACE BURNERS DO NOT SPARK WHEN THE CONTROL IS TURNED TO IGNITE
Frigidaire / Electrolux Range Spark ignition switch and wire harness assembly 316219004, Fixes One or more surface burners do not spark when the control is turned to ignite
Genuine OEM range assembly containing the surface-burner spark-ignition switches and complete wire harness. The assembly serves the top burners and is used on gas ranges.
Part 316219004Replaces 316219000Frigidaire / Electrolux
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part Number316219004
Replaces316219000
ManufacturerFrigidaire / Electrolux
Appliance TypeRange
Part TypeSpark ignition switch and wire harness assembly
✅ Cross Reference Information
Current Part Number316219004
Replaces316219000
Common Symptoms
- A surface burner produces no spark or clicking when operated.
- Ignition is intermittent on one or more surface burners.
- The ignition switch or harness may cause continuous clicking or sparking.
- Visible heat damage, chafing, or loose terminals may interrupt ignition-circuit continuity.
Check Before Replacing
- With the range cool, visually inspect the harness, connectors, and switch wiring for loose terminals, chafing, melted insulation, or heat damage.
- Compare the affected burner position with other burner positions to determine whether the symptom is isolated to a switch/harness circuit or affects the complete ignition system.
- After disconnecting electrical power and shutting off the gas supply, verify that the replacement assembly has the same connector arrangement and wiring layout as the installed assembly.
- Have a qualified technician test switch continuity and ignition-circuit voltage according to the appliance service documentation; do not probe energized wiring unless properly trained.
Pro Tip
If ignition trouble is limited to one burner position, inspect that position's switch connector and nearby harness routing for heat or terminal damage before replacing other ignition components.
Part Details
Part Number316219004
Part TypeSpark ignition switch and wire harness assembly
ManufacturerFrigidaire / Electrolux
Appliance TypeRange
Primary FunctionSupplies and switches the surface-burner spark-ignition circuits for the range, including the complete top-burner wire harness.
Installation Notes
- Disconnect electrical power and shut off the gas supply before installation.
- Allow the range to cool before accessing the harness or switches.
- Follow the model-specific installation or service instructions because access and routing can vary by range model.
- Preserve the original harness routing and ensure connectors are fully seated and clear of burner heat after installation.
- Verify the exact appliance model and connector arrangement before ordering or fitting the assembly.
Verified Compatible Models
CFGF337ESC, CFGF337ESD, CFGF366DBB, CFGF366DBD, CFGF366DBF, CFGF366DCC, CFGF366DCD, CFGF366DCF, CFGF366DCG, CFGF366DSB, CFGF366DSD, CFGF366DSF, CFGF366FBA, CFGF366FBB, CFGF366FBC
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
