OEM REPLACEMENT PART
316462808 Frigidaire Range Electronic Control Board
Part# 316462808
Fits Frigidaire
Fits Electrolux
Frigidaire Range Not Responding? Electronic Control Board 316462808 – Restore Full Oven Function
If your Frigidaire range has a blank display, unresponsive controls, or an oven that won’t heat despite the burners working, the electronic control board is the most likely cause. In Frigidaire and Electrolux freestanding and slide-in ranges, this board manages all oven functions — bake and broil element switching, temperature regulation, timer, and control panel input. When it fails, the oven may be completely dead, stuck in a mode, or unable to hold temperature. ⚡ Common failure point in Frigidaire-built ranges. Part 316462808 is the genuine OEM replacement board that restores full oven operation immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Range has power — surface burners ignite or surface elements heat normally
- ✔ Oven temperature sensor has been tested and is within spec (approx. 1080Ω at room temp)
- ✔ Wiring harness connectors to the board are intact and fully seated
- ✔ ONLY problem is oven not heating, display blank/frozen, or controls unresponsive
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Oven display is blank or shows error codes that won’t clear
- Oven won’t heat — bake or broil elements not energizing
- Control panel buttons unresponsive or intermittently responsive
- Oven heats but won’t maintain set temperature — overshoots or undershoots
- Oven stuck in self-clean mode or won’t exit a cycle
- F-code error displayed repeatedly after power cycling
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this control board restores full oven operation immediately.
📦 Part Details
-
Part Number: 316462808
-
Type: Range Electronic Control Board — manages oven bake/broil switching, temperature regulation, display, timer, and control panel input
-
Condition: New — Genuine OEM
-
Brands: Frigidaire, Electrolux
⚠️ Test the Oven Temperature Sensor First:
Before replacing the control board, test the oven temperature sensor (RTD probe) with a multimeter — it should read approximately 1080Ω at room temperature. A failed sensor sends incorrect readings to the board and produces identical symptoms at a fraction of the cost. If the sensor tests good, the board is the confirmed next step.
⚙️ Installation
Skill Level: Moderate — 20 to 30 minutes. Disconnect power at the breaker before servicing. The control board is located behind the rear control panel — remove the back panel screws, photograph the wiring harness layout, disconnect all connectors, swap the board, and reconnect. Restore power and verify all oven functions before reassembling the panel.
✓ Compatible Models
Contact us with your model number to confirm compatibility before ordering.
💡 Pro Tip
Photograph the Wiring Harness Before You Disconnect Anything:
The control board has multiple harness connectors that are easy to mix up on reassembly. A 10-second photo before you pull anything saves 20 minutes of troubleshooting afterward. Also verify all connectors click fully seated after install — a partially connected harness produces the same symptoms as a failed board and is the most common cause of a “bad” new part return.
