Dishwasher Not Filling? 60" Stainless Steel Water Supply Connector 3241-600 – Fix Leaks & No-Fill Fast
A cracked or corroded dishwasher water supply line is one of the most common causes of no-fill and under-counter leaks. In most dishwasher installations, this is caused by a failed or degraded supply connector. When it fails, the dishwasher either won't fill at all, fills slowly, or leaks at the connection point — often going unnoticed until water damage appears. ⚡ Common failure point in aging dishwasher installations. Part 3241-600 is the genuine OEM-grade 60" stainless steel replacement connector that restores a secure, leak-free water supply connection immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your dishwasher powers on and cycles normally
- ✔ The control panel and door latch function correctly
- ✔ Your home water supply valve is fully open and confirmed working
- ✔ The drain pump and wash motor operate without issue
- ✔ ONLY problem is no fill, slow fill, or a visible leak at the water inlet connection
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Dishwasher not filling with water — most common, what customers search
- Visible water pooling under the dishwasher or at the cabinet base
- Dishwasher fills very slowly or incompletely
- Hissing or dripping sound from the supply line during or after a cycle
- Rust staining or mineral deposits around the connector fitting
- Connector hose is kinked, cracked, or shows visible corrosion
✔ If these symptoms match, the supply connector is the most likely failed component.
✔ In most cases, replacing this connector restores normal fill operation immediately.
📦 Part Details
- Part Number: 3241-600
- Type: 60" Braided Stainless Steel Dishwasher Water Supply Connector
- Replaces: OEM direct-fit supply line assembly — no modification required
- Material: Corrosion-resistant stainless steel braid with brass fittings
- Length: 60 inches — accommodates most standard under-counter dishwasher installations
While the dishwasher is pulled out, inspect the water inlet valve for mineral buildup or slow response — a failing inlet valve is often the root cause of slow-fill complaints and is inexpensive to replace at the same time. Replacing both together eliminates the two most common fill-system failure points in a single service call.
⚙️ Installation
Skill Level: EASY — 20–30 minutes. Shut off the water supply valve under the sink before beginning. Pull the dishwasher forward slightly to access the inlet fitting, disconnect the old connector, and thread the new 3241-600 onto the inlet valve and shut-off valve by hand before snugging with a wrench — do not overtighten brass fittings. Restore water supply and run a short cycle to confirm no leaks at either connection point.
💡 Pro Tip
Stainless steel supply connectors have a recommended service life of 5–10 years regardless of visible condition — internal rubber liners degrade before the braid shows wear. If your dishwasher is over 7 years old and you've never replaced the supply line, this is a low-cost preventive swap that avoids a much more expensive water damage claim. Keep a spare on hand if you manage multiple units.
Related repair guides: Dishwasher Parts Canada
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
