DRYER MOTOR RUNS POORLY OR THE DRUM DOES NOT TUMBLE
Bosch Dryer drive motor 436441, Fixes Dryer motor runs poorly or the drum does not tumble
Bosch dryer drive motor with pulley for 120-volt dryers. The motor drives the belt and rotates the dryer drum.
Part 436441Bosch
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part Number436441
ManufacturerBosch
Appliance TypeDryer
Part TypeDryer drive motor
Common Symptoms
- Drum does not tumble when the dryer is started
- Drum turns slowly or incompletely
- Motor-related grinding or abnormal operating noise
- Motor overheats or fails to start
Check Before Replacing
- With power disconnected, check whether the drum turns freely by hand before condemning the motor.
- Verify the drive belt and blower path are not mechanically obstructed.
- If the dryer hums but the drum does not turn, have the motor and related drive components electrically and mechanically tested by a qualified technician.
Pro Tip
Confirm the dryer model number before ordering; Bosch compatibility is model-specific.
Part Details
Part Number436441
Part TypeDryer drive motor
ManufacturerBosch
Appliance TypeDryer
Primary FunctionDrives the dryer belt and drum.
✅ Supersession Note: 00436441 supersedes 436441 and is the current documented manufacturer replacement.
Installation Notes
- Disconnect electrical power before service.
- Confirm the replacement motor and pulley arrangement against the dryer model and existing installation.
- Use appropriate hand protection when accessing internal dryer components.
Verified Compatible Models
Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
All brand names are the property of their respective owners and are used for compatibility reference only.
