Dryer Squealing, Thumping, or Grinding? Rear Bearing Kit 5303281153 — Fix It Fast
A dryer that squeals, thumps, or grinds on every cycle has a worn rear drum bearing — and the 5303281153 kit is the current OEM fix for the entire Frigidaire-platform dryer lineup. In most Frigidaire, Electrolux, and White-Westinghouse dryers, the rear drum bearing supports the back of the drum on a nylon bearing cup and felt ring. When the bearing wears out, the drum loses its rear support, causing metal-on-metal contact, loud squealing or thumping, and uneven drum rotation that worsens with every load. ⚡ One of the highest-volume wear parts in Frigidaire-platform dryers — this kit supersedes multiple older part numbers including 131825900. Part 5303281153 is the current OEM replacement kit that restores proper drum alignment, eliminates bearing noise, and protects the drum shaft from further wear.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ The dryer runs and heats normally — clothes are drying
- ✔ A loud squealing, thumping, or grinding noise occurs throughout the cycle
- ✔ Noise is coming from the rear of the drum, not the front
- ✔ Drum wobbles or feels loose when rotated by hand with the belt removed
- ✔ ONLY problem is drum noise — not a heating or electrical issue
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Loud squealing or squeaking noise during the entire dry cycle
- Thumping or rumbling from the rear of the dryer
- Grinding noise that worsens over time and with heavier loads
- Drum wobbles or feels unsteady when rotated by hand
- Visible wear, cracking, or breakage on the existing bearing cup
- Drum shaft showing scoring or wear marks
✔ If these symptoms match, the rear drum bearing is the most likely failed component.
✔ In most cases, replacing this bearing kit eliminates drum noise immediately and prevents drum shaft damage.
📦 Part Details
- Part Number: 5303281153
- Type: OEM Dryer Rear Drum Bearing Kit (Bearing Cup + Felt Seal)
- Replaces: 131825900, 31581400, 3281153, 724C138A02, 902088, 131378400, 131777700, 137086600, 137088600, 137088620, 137088630 — no modification required
- Brands: Frigidaire, Electrolux, White-Westinghouse, Gibson, Kelvinator, Tappan
While the dryer is open, replace the drum drive belt and idler pulley at the same time. These wear at the same rate as the rear bearing — a worn belt or pulley will cause noise to return within months. Replacing all three now saves a second disassembly and keeps the dryer running quietly for years.
⚙️ Installation
Skill Level: MODERATE — 45–60 minutes. Disconnect power before servicing. Remove the dryer front panel and drum to access the rear bearing assembly — typically requires removing 4–6 screws from the top panel and releasing the front panel clips. Slide the old bearing cup off the shaft, press the new cup into position until fully seated, replace the felt seal around the bearing, then reassemble in reverse order.
✓ Compatible Models
Confirmed compatible with hundreds of Frigidaire, Electrolux, White-Westinghouse, Gibson, and Kelvinator dryer models including AEQ6000CES0, AEQ7000CES0, AEQ8000CFS0, AGQ6000ES0, AGQ8000FS0, BCEQ6100FS0, CDE4000FW0, DE400KDW1, DE500KDW1, DE650KDW1, DECSFW0, DEDFW0, DEISFW0 and many more. Contact us to verify your model number before ordering.
💡 Pro Tip
If you searched for 131825900, 31581400, 3281153, or 724C138A02 — 5303281153 is the current OEM replacement for all of them. Frigidaire consolidated these into a single updated kit. You're in the right place.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
