Dishwasher Not Draining? Drain Pump 5304483444 – Fix Standing Water Fast
Standing water at the bottom of your dishwasher after every cycle is a clear sign the drain pump has failed. In most Frigidaire, Electrolux, and Kenmore dishwashers, this is caused by a failed drain pump motor. When it fails, dirty water cannot be expelled at the end of the wash cycle — leaving dishes sitting in contaminated water and blocking the next cycle from starting. ⚡ Common failure point in Frigidaire-platform dishwashers. Part 5304483444 is the genuine OEM replacement that restores full drainage and gets your dishwasher running normally again.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Dishwasher powers on and completes the wash cycle normally
- ✔ Spray arms and wash functions work correctly
- ✔ Water supply and inlet valve confirmed OK
- ✔ ONLY problem is water remaining in the tub after the cycle ends
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Standing water in the bottom of the dishwasher after the cycle completes
- Dishwasher stops mid-cycle with water still inside the tub
- Humming or grinding noise during the drain phase with no water movement
- Error codes related to draining (e.g., i30, i50 on Frigidaire/Electrolux models)
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this drain pump restores normal drainage immediately.
📦 Part Details
- Part Number: 5304483444
- Type: OEM Dishwasher Drain Pump Motor Assembly
- Replaces: 5304482500, B20-3, 11001011000095
- Brands: Frigidaire, Electrolux, Kenmore
While the dishwasher is open, inspect the drain hose and check valve for cracks or blockages — a compromised hose can cause the new pump to fail prematurely. Replacing both at the same time eliminates the need for a second service call.
⚙️ Installation
Skill Level: Moderate — 45–60 minutes. Disconnect power and shut off the water supply before servicing. Remove the lower spray arm and filter assembly to access the pump housing, disconnect the wiring harness and drain hose, then install the new pump and reassemble in reverse order. Run a short rinse cycle to confirm full drainage before closing up.
✓ Compatible Models
Confirmed compatible with Frigidaire FFBD1821MS0A, FFBD1821MW0A, FDB2410HIS2A, FDB2410HIC2A, Electrolux EIDW1805KS0A, EIDW1805KS1B, Kenmore 58714652110, 58714659110, 58714662110, 58714663110, 58714669110, and additional Frigidaire-platform models. Contact us to verify your model number before ordering.
💡 Pro Tip
A severely clogged dishwasher filter can mimic a failed drain pump — remove and rinse it first. If standing water persists after one full cycle with a clean filter, the pump motor has failed and this is your fix. Cleaning the filter at the same time as the pump replacement significantly extends the life of the new part.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
