DISHWASHER LEAVES WATER IN THE TUB AFTER THE DRAIN PHASE
Frigidaire / Electrolux Dishwasher Drain Pump 5304483444, Fixes Dishwasher leaves water in the tub after the drain phase
Genuine OEM drain pump that removes water from the dishwasher tub during the drain phase of the dishwashing cycle.
Part 5304483444Replaces 5304482500Frigidaire / Electrolux
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part Number5304483444
Replaces5304482500
ManufacturerFrigidaire / Electrolux
Appliance TypeDishwasher
Part TypeDishwasher Drain Pump
✅ Cross Reference Information
Current Part Number5304483444
Replaces5304482500
Common Symptoms
- Standing water remains in the dishwasher after a completed cycle.
- Humming, buzzing, or grinding occurs during draining with little or no water movement.
- The dishwasher may stop or fail to complete a cycle because water was not removed.
- Possible leakage from the pump or motor area if the pump assembly is damaged.
Check Before Replacing
- Disconnect electrical power before inspecting the pump or its wiring.
- Check and clean the dishwasher filter and sump area for debris before condemning the pump.
- Inspect the drain hose for kinks, blockages, or improper routing, and verify that the disposer inlet knockout has been removed if applicable.
- During a commanded drain phase, listen for pump operation and observe whether water moves through the drain hose; do not treat this observation alone as proof of pump failure.
- With power disconnected, inspect the pump wiring connector and visible housing for looseness, damage, or leakage.
- If appropriate for the appliance service procedure, test the pump motor for continuity with power disconnected; an abnormal result supports further diagnosis but does not by itself identify every possible drain fault.
Pro Tip
Check the filter, sump, drain hose, and disposer connection before replacing the pump, because restrictions elsewhere in the drain path can produce similar symptoms.
Part Details
Part Number5304483444
Part TypeDishwasher Drain Pump
ManufacturerFrigidaire / Electrolux
Appliance TypeDishwasher
Primary FunctionRemoves wastewater from the dishwasher tub during the drain phase by pumping it into the drain hose.
Installation Notes
- Disconnect electrical power and shut off the water supply before servicing.
- Use the model-specific service or installation documentation because access and pump-retention details vary by dishwasher design.
- Before installation, compare the replacement pump, electrical connector, outlet, and hose connection with the removed component.
- Reconnect the wiring harness and drain hose securely, following the appliance-specific routing and clamp requirements.
- After reassembly, run a short rinse or drain test and check for proper water removal and leaks before returning the dishwasher to normal use.
Verified Compatible Models
58712332F01B, 58712333F01B, 58712339F01B, 58712332510A, 58712333510A, 58712339510A, 58714652110, 58714652200A, 58714652201B, 58714659110, 58714659200A, 58714659201B, 58714662110, 58714662200A, 58714662201B
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
All brand names are the property of their respective owners and are used for compatibility reference only.
