Oven Not Heating Correctly? 5304504897 Temperature Sensor – Fix Uneven Temps Fast

An oven that runs too hot, too cold, or wildly inconsistent almost always points to a failed temperature sensor. In most Frigidaire and Electrolux electric ranges and ovens, this is caused by a failed RTD temperature sensor probe — the component that continuously reports cavity temperature to the control board. When it fails, the board can’t regulate the heating elements accurately, leading to burnt food, undercooked meals, and temperature error codes. ⚡ One of the most common electronic failures in Frigidaire-platform ovens. Part 5304504897 is the genuine OEM replacement sensor that restores accurate temperature control and eliminates error codes immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your oven powers on and the control panel is responsive
• ✔ The bake and broil elements glow red and produce heat (elements are not burned out)
• ✔ The oven control board has no visible burn marks or damage
• ✔ The oven door seal is intact and the door closes fully
• ✔ ONLY problem is inaccurate temperature, uneven cooking, or an F10/F11/F30 error code

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Oven temperature too hot or too cold — most common reason customers search for this part
• Food burning on the outside but undercooked inside
• Oven takes much longer than normal to preheat
• Oven overshoots the set temperature and won’t regulate
• F10, F11, F30, or F31 error code displayed on the control panel
• Oven shuts off unexpectedly mid-cycle due to runaway temperature reading

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this temperature sensor restores accurate oven temperature control immediately.

📦 Part Details

• Part Number: 5304504897
• Type: OEM Oven RTD Temperature Sensor Probe
• Replaces: OEM direct-fit temperature sensor — supersedes 318562500 (no modification required)
• Brands: Frigidaire, Electrolux, and Frigidaire-platform brands

⚙️ Installation

Skill Level: EASY — 10 to 15 minutes. Disconnect power to the range or oven at the breaker before beginning. The sensor is located on the rear wall of the oven cavity, secured by two screws — remove the screws, pull the sensor forward, disconnect the wiring harness, and connect it to 5304504897. Reinstall the screws, restore power, and run a preheat cycle to verify the temperature reads accurately. Do not overtighten the mounting screws — finger-tight plus a quarter turn is sufficient.

✓ Compatible Models

Confirmed compatible with DF240161, DF241161, DF241761, DF260141, DF260142, DF260161, DF260162, DF261161, DF261162, DF460161, DF460162, DF461161, DF461162, DI260130, DI460111, DI460112, DI460113, plus additional Frigidaire and Electrolux oven and range models. Contact us to verify your model number before ordering.

💡 Pro Tip