Frigidaire Washer Door Won’t Latch or Pops Open? Door Strike 5304505088 – Fix It Fast

If your Frigidaire front-load washer door won’t latch, pops open mid-cycle, or the washer won’t start because it can’t detect a closed door, the door strike is the most likely cause. In most Frigidaire and Electrolux front-load washers, the door strike is the plastic catch on the door that engages the door lock assembly on the cabinet — when the strike breaks, wears, or cracks, the door lock cannot engage, the washer’s safety circuit stays open, and the machine will not run. ⚡ Most common door latch failure point on Frigidaire front-load washers. Part 5304505088 is the genuine OEM replacement door strike that restores a secure latch and re-engages the safety circuit for immediate normal operation.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and control panel responds normally
• ✔ Door lock assembly (5304514774) has been confirmed working
• ✔ Door hinge and door boot seal are intact and undamaged
• ✔ The door strike is visibly cracked, broken, or worn smooth
• ✔ ONLY problem is door won’t latch, pops open, or washer won’t start due to door detection failure

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Washer door won’t latch or click shut — strike broken or worn
• Washer won’t start — door safety circuit open due to failed strike engagement
• Door pops open mid-cycle — strike no longer holds against door lock
• Water leaking from door — door not sealing fully due to latch failure
• Door feels loose or rattles during operation — strike cracked but not fully broken
• Door lock clicks but drum won’t spin — strike not engaging lock sensor correctly

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this door strike restores a secure latch and full washer operation immediately.

📦 Part Details

• Part Number: 5304505088
• Type: Front-Load Washer Door Strike / Door Catch
• Fit: OEM direct-fit replacement (no modification required)
• Brands: Frigidaire, Electrolux, and related brands built on the same platform

⚙️ Installation

Skill Level: Easy — 10–20 minutes. No power disconnect required for strike replacement on most models, but unplugging is always recommended. Open the washer door and locate the strike on the door’s inner edge — it is typically secured by one or two screws or press-fit clips. Remove the old strike, snap or screw the new strike into position, and close the door to confirm the latch engages cleanly. Run a short cycle to verify the door holds and the washer starts normally.

✓ Compatible Models

Confirmed compatible with: EFLS517SIW0, EFLS517STT0, EFLS527UIW0, EFLS527UIW1, EFLS527UIW2, EFLS527UTT0, EFLS527UTT1, EFLS527UTT2, EFLS617SIW0, EFLS617STT0, EFLS627UIW0, EFLS627UIW1, EFLS627UIW2, EFLS627UTT0, EFLS627UTT1, EFLS627UTT2, EFLS628WTT00, EFLW317TIW0, EFLW317TIW1, EFLW317TIW2, EFLW427UIW0, EFLW427UIW1, EFLW427UIW2, ELFW7337AW0, ELFW7437AW0, ELFW7537AT0, ELFW7537AW0, ELFW7637AT0, ELFW7637AW0, ELFW7637BT0, ELFW7637BW0, plus additional Frigidaire and Electrolux models. Contact us to verify your model number before ordering.

💡 Pro Tip

✓ Model-Specific Repair Pages