Washer Not Cleaning Clothes? 5304514769 Circulation Pump Assembly – Fix Wash Performance Fast

If your Electrolux or Frigidaire washer is leaving clothes dirty, not agitating water properly, or running cycles without effective cleaning, the circulation pump assembly is the most likely cause. In most Electrolux front-load washers, the circulation pump recirculates wash water through the drum during the wash cycle — when it fails, water sits stagnant, detergent doesn’t distribute, and clothes come out unwashed or soapy. ⚡ Common failure point in Electrolux and Frigidaire front-load washers. Part 5304514769 is the genuine OEM replacement that restores full water circulation and effective wash performance.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and cycles run to completion
• ✔ Drain pump is working — water drains at end of cycle
• ✔ Door latch and lid switch are functioning correctly
• ✔ Drum spins and motor runs normally
• ✔ ONLY problem is poor cleaning results, detergent residue on clothes, or no visible water movement during wash phase

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Clothes coming out dirty or with detergent residue after a full cycle — most common complaint
• Washer runs but water doesn’t appear to circulate through the drum
• Unusual humming or grinding noise during the wash phase
• Detergent dispenser empties but soap isn’t reaching the drum
• Error code related to wash motor or circulation system
• Clothes come out soaking wet with no cleaning effect

✔ If these symptoms match, the circulation pump is the most likely failed component in the system.

✔ In most cases, replacing the circulation pump assembly restores full wash performance immediately.

📦 Part Details

• Part Number: 5304514769
• Type: Washer circulation pump assembly — complete motor and pump unit
• Replaces: OEM direct-fit assembly (no modification required)
• Brands: Electrolux, Frigidaire

⚙️ Installation

Skill Level: MODERATE — 45–60 minutes. Unplug the washer and shut off the water supply before beginning. Access the circulation pump by removing the front lower access panel or tilting the machine back depending on your model. Disconnect the wiring harness and hose connections from the old pump, mount the new 5304514769 in the same orientation, reconnect all hoses and the harness securely, then run a test cycle to confirm normal water circulation before reinstalling the access panel.

💡 Pro Tip