Washer Not Spinning? Drive Motor 5304515226 – Fix No-Spin & Drum Faults Fast

If your Frigidaire or Electrolux front-load washer won't spin, agitate, or tumble, the drive motor is the most common cause. In most Frigidaire-built front-load washers, the drive motor powers the drum directly through a belt or direct-drive coupling. When it fails, the drum stops moving entirely, the washer may hum without spinning, or the cycle will abort mid-wash. ⚡ Common failure point in Frigidaire and Electrolux front-load washers. Part 5304515226 is the genuine OEM replacement that restores full drum rotation and normal wash cycle operation.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on — control panel lights up and responds
• ✔ Water fills and drains correctly — pump is functioning
• ✔ Power supply confirmed OK — outlet, cord, and door latch are fine
• ✔ Drive belt (if applicable) has been inspected and is intact
• ✔ ONLY problem is drum not spinning, tumbling, or agitating

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Washer drum not spinning or tumbling — most common complaint
• Washer hums or buzzes but drum doesn't move
• Spin cycle starts then stops mid-cycle
• Clothes come out soaking wet — no spin achieved
• Error codes E47, E48, or motor fault codes displayed
• Burning smell from motor area during attempted spin

✔ If these symptoms match, the drive motor is the most likely failed component in the system.

✔ In most cases, replacing this drive motor restores full spin and tumble operation immediately.

📦 Part Details

• Part Number: 5304515226
• Type: Washer Drive Motor Assembly
• Replaces: OEM direct-fit drive motor assembly — supersedes 134856401, 137151200 (no modification required)
• Brands: Frigidaire, Electrolux, Kenmore (Frigidaire-built)

⚙️ Installation

Skill Level: MODERATE — 45–60 minutes. Unplug the washer and shut off water supply before beginning. Access the motor by removing the front panel or rear access panel depending on model; disconnect the wire harness and motor mounting bolts, swap the motor, and reassemble in reverse order. Photograph all harness connections before disconnecting — motor connector orientation matters for correct rotation direction.

✓ Compatible Models

Confirmed compatible with FAFS4272LW0, FAFS4272LW1, FAFS4474LW0, EFLS527UIW0, EFLS627UIW0, EFLS627UTT0, plus additional Frigidaire and Electrolux front-load washer models. Contact us to verify your model number before ordering.

💡 Pro Tip