The 8280503 is the OEM cycle selector switch for Whirlpool and Kenmore top-load direct-drive washers. This rotary switch controls which wash cycle the machine runs — Normal, Delicate, Permanent Press, and more. When it fails, the washer may not start, may skip cycles, get stuck on a single setting, or fail to advance through the wash sequence. It’s one of the most common control panel repairs on older Whirlpool-platform top-loaders.

✓ Model-Specific Repair Pages

The 8280503 cycle selector switch is a direct OEM replacement for Whirlpool-platform top-load washers. It mounts to the control panel and connects via a wiring harness to the timer and motor circuit. This switch is compatible with a wide range of Whirlpool, Kenmore, Roper, and Estate top-load washer models built on the direct-drive platform.

✓ Common Symptoms Fixed

Washer won’t start when cycle is selected — Washer stuck on one cycle setting — Cycle selector knob spins freely with no response — Washer skips or won’t advance through cycles — Intermittent starting issues depending on cycle selected

✓ Key Features & Specifications

OEM Part Number: 8280503 — Type: Rotary cycle selector switch — Compatible with Whirlpool, Kenmore, Roper, Estate top-load direct-drive washers — Mounts to control panel — Sold individually

✓ Buying Options

New (OEM): Factory-original cycle selector switch sourced from authorized OEM distribution. Guaranteed fit and full service life. Aftermarket replacement parts are not affiliated with, sponsored by, or endorsed by Whirlpool or any OEM manufacturer.

Used (Tested): A pull from a working machine, tested for function. Ideal for older washers where a new OEM part may be hard to justify on cost. Used parts are sold as-is with no warranty.

✓ Replacement Part Numbers

8280503 (OEM) — 8280503XP (aftermarket cross-reference)

✓ Installation Tips

Unplug the washer before beginning any repair. Remove the control panel by releasing the clips or screws at the back of the top panel. Disconnect the wiring harness from the old switch, noting connector positions. Press the new switch into the panel mount and reconnect the harness. Reinstall the control panel and plug the washer back in. Test all cycle positions before reassembling fully. Most installations take 15–30 minutes.