Dishwasher Not Starting or Showing Error Codes? Asko Control Board 906252 – Fix Cycle Failures Fast
If your Asko dishwasher won't start, displays error codes, or stops mid-cycle, a failed control board is the most likely cause. In most Asko dishwashers, the control unit board manages every stage of the wash cycle — from water intake and heating to pump operation and drain sequencing. When it fails, the dishwasher may refuse to start, display fault codes, freeze mid-cycle, or behave erratically with buttons and programs not responding correctly. ⚡ Common failure point in Asko-built dishwashers, especially after power surges or moisture ingress. Part 906252 is the genuine OEM replacement that restores full electronic control and allows all wash programs to run correctly.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Dishwasher has power and display lights up (or partially lights up)
- ✔ Water supply and drain hose are confirmed clear and connected
- ✔ Door latch and microswitch have been ruled out as the cause
- ✔ ONLY problem is error codes, no-start condition, or unresponsive program selection
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Dishwasher displays error or fault codes and won't clear
- Machine won't start any wash program despite door being latched
- Cycle stops partway through and cannot be resumed
- Control panel buttons unresponsive or behaving erratically
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this control board restores full dishwasher operation immediately.
📦 Part Details
- Part Number: 906252
- Type: Dishwasher Electronic Control Unit / PCB Assembly
- Brands: Asko
While the control board is out, inspect the wiring harness connectors for corrosion or burn marks — damaged connectors can cause the same fault codes to return on a new board. Clean or replace any corroded terminals before reinstalling.
⚙️ Installation
Skill Level: MODERATE — 30–50 minutes. Disconnect power before servicing. Remove the inner door panel to access the control board housing, photograph all wiring harness connections before disconnecting, swap the board, reconnect all harnesses in the correct positions, and reassemble the door before restoring power to test.
✓ Compatible Models
Confirmed compatible with select Asko dishwasher models. Contact us to verify your model number before ordering.
💡 Pro Tip
Control boards on Asko dishwashers often have 6–10 individual harness connectors. Before pulling any connector, take a clear photo of the full board with all wiring in place — this makes reinstallation straightforward and eliminates the risk of a misconnected harness causing a new fault on startup.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
