HVAC & Equipment V-Belt A158, Replaces Gates 9002-2158, Timken AP158

The A158 V-belt transfers motor power to a compatible driven sheave. Match the original belt by section, width, length and duty rating before ordering.

Cross-Reference Information

Important: Exact classical cross-references share the same industry section and nominal length. FHP and cogged alternatives may use different construction, minimum pulley diameter, effective length or service rating. Verify the equipment requirements before substituting.

Is This the Right Belt?

Confirm the complete marking on the original belt. Similar belts can share an outside length while using a different cross section, depth, effective length or construction.

Common Symptoms

• Belt slips under load
• Squealing, chirping or belt dust
• Fan, blower, pump or driven component turns slowly
• Belt is cracked, glazed, stretched or frayed

Check Before Replacing

• Confirm the A-section profile and 1/2" / 12.7 mm top width
• Confirm the required 160-inch outside length
• Inspect pulleys and sheaves for wear, rust, glazing or debris
• Check alignment, bearing condition and belt tension

Part Details

Installation Notes

1. Disconnect and lock out electrical power.
2. Relieve belt tension according to the equipment service manual.
3. Inspect and clean the pulleys before fitting the replacement belt.
4. Align the pulleys and set tension to the equipment manufacturer's specification.
5. Rotate the drive by hand, reinstall guards, restore power and test operation.

Verified Compatible Equipment Models

No manufacturer-published model-level fitment was verified for this universal classical belt. Official sources list broad industrial applications such as fans, blowers, pumps, conveyors, mixers and general machinery.

Fitment reminder: Match the original belt designation, section and length. Do not order by equipment category alone.