WARM REFRIGERATOR TEMPERATURES CAUSED BY A DOOR SEAL THAT IS NOT CLOSING AIRTIGHT
LG Refrigerator Door Gasket Assembly ADX73350635, Fixes Warm refrigerator temperatures caused by a door seal that is not closing airtight
Genuine LG refrigerator door gasket assembly that forms an airtight seal around the refrigerator door to retain cold air and prevent warm-air intrusion, frost, and moisture buildup. The part is also listed for selected Kenmore refrigerators.
Part ADX73350635Replaces ADX73350625LG
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberADX73350635
ReplacesADX73350625
ManufacturerLG
Appliance TypeRefrigerator
Part TypeDoor Gasket Assembly
✅ Cross Reference Information
Current Part NumberADX73350635
ReplacesADX73350625
Common Symptoms
- Visible cracking, tearing, flattening, or compression of the gasket
- Condensation or moisture around the refrigerator door opening
- Frost or ice buildup near the door seal
- Refrigerator runs longer than usual while trying to maintain temperature
- Door does not contact the cabinet evenly or appears slightly ajar
Check Before Replacing
- Visually inspect the entire gasket for tears, cracks, deformation, or flattened sections.
- Clean the gasket and the mating cabinet surface, then check whether the door closes evenly.
- With the door closed, inspect for visible gaps between the gasket and cabinet around the perimeter.
- Check that stored food or door bins are not obstructing full door closure.
- Verify that the gasket is seated continuously in its door groove, especially at the corners.
Pro Tip
If the replacement gasket is compressed from packaging, gently warm it with warm water or low heat from a hair dryer and reshape it before installation; avoid overheating or stretching it excessively.
Part Details
Part NumberADX73350635
Part TypeDoor Gasket Assembly
ManufacturerLG
Appliance TypeRefrigerator
Primary FunctionForms the airtight magnetic seal between the refrigerator door and cabinet to retain cold air and limit warm-air, moisture, and frost entry.
Installation Notes
- Disconnect refrigerator power before beginning installation.
- Remove the old gasket carefully without damaging the door liner or retaining groove.
- Ensure the door groove is clean before fitting the replacement.
- Press the gasket ridge into the groove, seating the corners and then the remaining sides evenly.
- Confirm that the flaps face outward as shown in the part-specific installation guide.
- Close the door and inspect the gasket from the side to verify continuous, even contact before restoring power.
Verified Compatible Models
LFC24770SB, LFC24770ST, LFC24770SW, LFC24786SB, LFC24786SD, LFC24786ST, LFC24786SW, LFCS25663S, LFX25978SB, LFX25978SW, LFXS24623B, LFXS24623D, LFXS24623S, LFXS24623W, LFXS24663S
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
