HVAC & Equipment V-Belt B315, Replaces Timken B315, Timken BP315, Dayco B315GL

The B315 V-belt transfers motor power to a compatible driven sheave. Match the full original belt designation and the equipment manufacturer's specifications before ordering.

Cross-Reference Information

Length note: The B number is an industry classical designation. Published inside, datum and outside lengths can differ by manufacturer and measurement method. Use the exact marked part number rather than measuring a loose belt by hand.

Common Symptoms

• Belt slips or squeals under load
• Driven fan, blower, pump or conveyor runs slowly
• Black belt dust develops around the sheaves
• Belt is cracked, glazed, stretched or frayed

Check Before Replacing

• Confirm the B-section profile and complete original belt marking
• Inspect sheaves for wear, polishing, rust or dished grooves
• Check shaft alignment and bearing condition
• Confirm the required service rating and tension specification

Installation Notes

1. Disconnect and lock out electrical power.
2. Relieve drive tension according to the equipment service manual.
3. Do not pry the belt over a pulley; create sufficient slack.
4. Align the pulleys and set tension to the equipment manufacturer's specification.
5. Rotate the drive by hand, reinstall guards, restore power and test operation.

Verified Compatible Equipment Models

No manufacturer-published model-level fitment was verified for this universal classical belt. Match by the exact belt designation, section and equipment requirements—not equipment type alone.