GE Washer Capacitor & Bracket Kit WG04A04234
Genuine OEM GE washer capacitor and bracket kit. Distributor documentation identifies it as a repair part for washer no-start, agitator-not-spinning, and unusual-smell symptoms; these symptoms are guidance rather than a diagnostic guarantee.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ QUALIFIER 1 — Washer powers on and control panel responds normally
- ✔ QUALIFIER 2 — Motor hums or attempts to start but drum does not turn
- ✔ QUALIFIER 3 — Lid switch, door latch, and drive belt confirmed OK
- ✔ ONLY problem is motor failing to start or spin under load
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Washer hums loudly but drum does not move during wash or spin cycle
- Motor starts briefly then shuts off — thermal overload tripping
- Agitator moves weakly or intermittently with reduced torque
- Spin cycle fails to reach full speed or stops mid-cycle
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this motor capacitor restores full spin and agitation immediately.
✅ Cross Reference Information
Part Number: WG04A04234
Previous Part Numbers: WW01F01786, WG04F09372
Part Details
- Part Number: WG04A04234
- Part Type: Washer Capacitor & Bracket Kit
- Manufacturer: GE
- Appliance Type: Washer
While the motor area is accessible, inspect the motor thermal overload protector and drive belt for wear. A failing capacitor often causes the motor to overheat repeatedly — if the thermal overload has been tripping for an extended period, it may be weakened and worth replacing at the same time to prevent a repeat no-start condition.
⚙️ Installation
Skill Level: MODERATE — 20–40 Minutes. Disconnect power and discharge the capacitor before handling — capacitors can hold a charge even after power is removed. Access the motor compartment by removing the washer cabinet or rear panel depending on model, disconnect the capacitor wiring terminals, swap the capacitor, and restore power to test spin operation before reassembling.
Verified Compatible Models
GTW330BMK1WW, GTW460AMJ5WW, GTW460ASJ0WW, GTW460BMK0WW, GTW460BMK1WW, GTW465BMK1WS, GTW485ASJ1WS, GTW485BMK0WS, GTW680BMK0DG, GTW680BMK0WS, GTW680BSJ0WS, GTW680BSJ1WS
Fitment reminder: Match the complete appliance model number before ordering.
💡 Pro Tip
Before removing the old capacitor, short its terminals together using an insulated screwdriver or a resistor — a charged capacitor can deliver a painful and dangerous shock even with the washer unplugged. This is the single most important safety step when servicing motor capacitors and takes less than 10 seconds to do correctly.
Verified Compatible Models
GTW330BMK1WW, GTW460AMJ5WW, GTW460ASJ0WW, GTW460BMK0WW, GTW460BMK1WW, GTW465BMK1WS, GTW485ASJ1WS, GTW485BMK0WS, GTW680BMK0DG, GTW680BMK0WS, GTW680BSJ0WS, GTW680BSJ1WS
Fitment reminder: Match the complete appliance model number before ordering.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
