Samsung Washer Leaking Around the Door? DC64-03788A Door Boot Seal – Fix Drum Seal Failures Fast
If your Samsung front-load washer is leaking water onto the floor during or after a cycle, the door boot seal is the most common cause. In most Samsung front-load washers, the door boot seal (also called the door gasket or bellow) creates the watertight barrier between the drum and the door glass. When it cracks, tears, or develops mold that can't be cleaned away, water escapes onto the floor and the drum interior is exposed to contamination. ⚡ Common failure point in Samsung WF45 and WF46-series front-load washers. Part DC64-03788A is the genuine OEM replacement that restores a watertight drum seal and eliminates door leaks in a direct-fit swap.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Washer powers on and runs cycles normally
- ✔ Water supply hoses and inlet valve are confirmed leak-free
- ✔ Drain pump and hose connections are intact with no leaks
- ✔ Door latch closes and locks correctly
- ✔ ONLY problem is water leaking from around the door opening or visible damage/mold on the rubber gasket
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Water pooling on the floor in front of the washer during or after a cycle
- Visible tears, cracks, or holes in the rubber door gasket
- Black mold or mildew embedded in the gasket folds that won't clean off
- Musty or sour odor coming from the door seal area
- Water marks or staining on the door glass or drum lip
- Gasket pulling away from the drum or door opening
✔ If these symptoms match, the door boot seal is the most likely failed component in the system.
✔ In most cases, replacing this door boot seal eliminates leaks and restores a clean, watertight drum seal immediately.
📦 Part Details
- Part Number: DC64-03788A
- Type: Front-Load Washer Door Boot Seal — drum-to-door rubber gasket / bellow assembly
- Replaces: OEM direct-fit door boot seal — genuine Samsung part, no modification required
- Supersedes: DC64-03788C
- Brands: Samsung
While the door boot is removed, inspect the door latch assembly and drain pump filter — both are common wear items on this platform and are far easier to service with the gasket already out. Addressing all three in one visit eliminates the most frequent sources of future leaks and odors.
⚙️ Installation
Skill Level: Moderate — 45–60 minutes. Disconnect power and water supply before beginning. Remove the door seal retaining spring clip (front), peel the old gasket off the drum lip, clean the drum flange thoroughly, seat the new gasket starting at the top center and work around both sides, then reinstall the retaining spring clip. Run an empty rinse cycle to confirm no leaks before loading laundry.
💡 Pro Tip
Any residue, mold, or debris on the drum lip will prevent the new gasket from seating evenly and can cause a new leak within weeks. Wipe the entire drum flange with a diluted bleach solution and let it dry completely before pressing the new seal into place — a clean surface is the single biggest factor in gasket longevity.
Model hub pages: WF45R6300AV, WF45A6400AW, WF50A8600AV, WF46BB6700AD, WF45T6000AV
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
